On 3/2/2022 2:54 PM, Dmitry Baryshkov wrote:
The number of interrupt cells for the mdss interrupt controller is 1,
meaning there should only be one cell for the interrupt number, not two.
Drop the second cell containing (unused) irq flags.
Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Fixes: 12d540375736 ("arm64: dts: qcom: msm8996: Add DSI0 nodes")
Fixes: 3a4547c1fc2f ("arm64: qcom: msm8996.dtsi: Add Display nodes")
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
Reviewed-by: Abhinav Kumar <quic_abhinavk@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8996.dtsi | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8996.dtsi b/arch/arm64/boot/dts/qcom/msm8996.dtsi
index f0f81c23c16f..0597d865a4a6 100644
--- a/arch/arm64/boot/dts/qcom/msm8996.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8996.dtsi
@@ -788,7 +788,7 @@ mdp: mdp@901000 {
reg-names = "mdp_phys";
interrupt-parent = <&mdss>;
- interrupts = <0 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <0>;
clocks = <&mmcc MDSS_AHB_CLK>,
<&mmcc MDSS_AXI_CLK>,
@@ -834,7 +834,7 @@ dsi0: dsi@994000 {
reg-names = "dsi_ctrl";
interrupt-parent = <&mdss>;
- interrupts = <4 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <4>;
clocks = <&mmcc MDSS_MDP_CLK>,
<&mmcc MDSS_BYTE0_CLK>,
@@ -904,7 +904,7 @@ hdmi: hdmi-tx@9a0000 {
"hdcp_physical";
interrupt-parent = <&mdss>;
- interrupts = <8 IRQ_TYPE_LEVEL_HIGH>;
+ interrupts = <8>;
clocks = <&mmcc MDSS_MDP_CLK>,
<&mmcc MDSS_AHB_CLK>,
