The change is wanted to postpone initialization of busses on CCI controller
by cci_init() and cci_reset() till adapters are registered, the later is
needed for adding I2C bus devices and get correspondent vbus regulators.
Signed-off-by: Vladimir Zapolskiy <vladimir.zapolskiy@xxxxxxxxxx>
---
drivers/i2c/busses/i2c-qcom-cci.c | 17 ++++++++---------
1 file changed, 8 insertions(+), 9 deletions(-)
diff --git a/drivers/i2c/busses/i2c-qcom-cci.c b/drivers/i2c/busses/i2c-qcom-cci.c
index cf54f1cb4c57..eebf9603d3d1 100644
--- a/drivers/i2c/busses/i2c-qcom-cci.c
+++ b/drivers/i2c/busses/i2c-qcom-cci.c
@@ -630,14 +630,6 @@ static int cci_probe(struct platform_device *pdev)
val = readl(cci->base + CCI_HW_VERSION);
dev_dbg(dev, "CCI HW version = 0x%08x", val);
- ret = cci_reset(cci);
- if (ret < 0)
- goto error;
-
- ret = cci_init(cci);
- if (ret < 0)
- goto error;
-
for (i = 0; i < cci->data->num_masters; i++) {
if (!cci->master[i].cci)
continue;
@@ -649,6 +641,14 @@ static int cci_probe(struct platform_device *pdev)
}
}
+ ret = cci_reset(cci);
+ if (ret < 0)
+ goto error_i2c;
+
+ ret = cci_init(cci);
+ if (ret < 0)
+ goto error_i2c;
+
pm_runtime_set_autosuspend_delay(dev, MSEC_PER_SEC);
pm_runtime_use_autosuspend(dev);
pm_runtime_set_active(dev);
@@ -663,7 +663,6 @@ static int cci_probe(struct platform_device *pdev)
of_node_put(cci->master[i].adap.dev.of_node);
}
}
-error:
disable_irq(cci->irq);
disable_clocks:
cci_disable_clocks(cci);
--
2.33.0
