On 1/13/2022 11:47 AM, Stephen Boyd wrote:
Quoting Kuogee Hsieh (2022-01-13 09:51:42)
On 1/12/2022 8:13 PM, Stephen Boyd wrote:
- if (dp->usbpd->orientation == ORIENTATION_CC2)
- flip = true;
+ dp_power_init(dp->power, false);
+ dp_ctrl_reset_irq_ctrl(dp->ctrl, true);
+
+ /*
+ * eDP is the embedded primary display and has its own phy
+ * initialize phy immediately
Question still stands why we can't wait for hpd high from the eDP panel.
Also, I think "has its own phy" means that it's not part of a combo
USB+DP phy? Can you please clarify?
Correct, eDP has its dedicated phy which is not part of combo phy.
+ */
+ if (dp->dp_display.connector_type == DRM_MODE_CONNECTOR_eDP)
+ dp_display_host_phy_init(dp);
- dp_power_init(dp->power, flip);
- dp_ctrl_host_init(dp->ctrl, flip, reset);
dp_aux_init(dp->aux);
dp->core_initialized = true;
}
@@ -1306,20 +1330,23 @@ static int dp_pm_resume(struct device *dev)
dp->hpd_state = ST_DISCONNECTED;
/* turn on dp ctrl/phy */
- dp_display_host_init(dp, true);
+ dp_display_host_init(dp);
dp_catalog_ctrl_hpd_config(dp->catalog);
- /*
- * set sink to normal operation mode -- D0
- * before dpcd read
- */
- dp_link_psm_config(dp->link, &dp->panel->link_info, false);
if (dp_catalog_link_is_connected(dp->catalog)) {
+ /*
+ * set sink to normal operation mode -- D0
+ * before dpcd read
+ */
+ dp_display_host_phy_init(dp);
+ dp_link_psm_config(dp->link, &dp->panel->link_info, false);
sink_count = drm_dp_read_sink_count(dp->aux);
if (sink_count < 0)
sink_count = 0;
+
+ dp_display_host_phy_exit(dp);
Why is the phy exited on resume when the link is still connected? Is
this supposed to be done only when the sink_count is 0? And how does
this interact with eDP where the phy is initialized by the call to
dp_display_host_init() earlier in this function.
At beginning of dp_pm_resume bot core_initialized and phy_initialized
should be off.
However at the case of dongle still connected to DUT, we have to read
dongle dpcd to decided any hdmi connect to dongle (sink_count != 0). in
this case, we have to turn on phy to perform dpcd read and turn off phy
after read so the following plugged-in interrupt can be handled correctly.
}
dp->link->sink_count = sink_count;
Any response to the above two comments?
??
