On 08/14/2013 06:59 AM, Ivan T. Ivanov wrote: > From: "Ivan T. Ivanov" <iivanov@xxxxxxxxxx> > > MSM USB3.0 core wrapper consist of USB3.0 IP from Synopsys > (SNPS) and HS, SS PHY's control and configuration registers. > > It could operate in device mode (SS, HS, FS) and host > mode (SS, HS, FS, LS). > diff --git a/Documentation/devicetree/bindings/usb/msm-ssusb.txt b/Documentation/devicetree/bindings/usb/msm-ssusb.txt > +- clock-names : ... > + "sleep_a_clk" : Sleep clock, used when USB3 core goes into low ... > + "ref_clk" : Reference clock - used in host mode. ... > + "core_clk" : Master/Core clock, have to be >= 125 MHz for SS ... > + "iface_clk" : System bus AXI clock > + "sleep_clk" : Sleep clock, used when USB3 core goes into low ... > + "utmi_clk" : Generated by HS-PHY. Used to clock the low power I think it makes sense to remove "_clk" from all those names, unless the HW documentation really talks about a clock named e.g. iface_clk yet some other clock names in the documentation don't have the "_clk" suffix, e.g. the "xo I didn't quote. > +Sub nodes: > +========== That section title is the same style as all the other section title, so it's no obvious that this is a sub-node for the controller wrapper. Instead, I would suggest something more like: Required child nodes: > +- Sub node for "DWC3 USB3 controller". Then you can drop that since it's obvious. > + This sub node is required property for device node. The properties > + of this subnode are specified in dwc3.txt. That doesn't really say much. How about. ---------- A child node must exist to represent the core DWC3 IP block. The name of the node is not important. The content of the node is defined in dwc3.txt. ---------- -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
