Hi Florian,
On 10:02 Wed 21 Aug , Florian Fainelli wrote:
> On 8/20/24 07:36, Andrea della Porta wrote:
> > RaspberryPi RP1 is multi function PCI endpoint device that
> > exposes several subperipherals via PCI BAR.
> > Add an ethernet node for Cadence MACB to the RP1 dtso
> >
> > Signed-off-by: Andrea della Porta <andrea.porta@xxxxxxxx>
> > ---
> > arch/arm64/boot/dts/broadcom/rp1.dtso | 23 +++++++++++++++++++++++
> > 1 file changed, 23 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/broadcom/rp1.dtso b/arch/arm64/boot/dts/broadcom/rp1.dtso
> > index d80178a278ee..b40e203c28d5 100644
> > --- a/arch/arm64/boot/dts/broadcom/rp1.dtso
> > +++ b/arch/arm64/boot/dts/broadcom/rp1.dtso
> > @@ -78,6 +78,29 @@ rp1_clocks: clocks@c040018000 {
> > <50000000>; // RP1_CLK_ETH_TSU
> > };
> > + rp1_eth: ethernet@c040100000 {
> > + reg = <0xc0 0x40100000 0x0 0x4000>;
> > + compatible = "cdns,macb";
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > + interrupts = <RP1_INT_ETH IRQ_TYPE_LEVEL_HIGH>;
> > + clocks = <&macb_pclk &macb_hclk &rp1_clocks RP1_CLK_ETH_TSU>;
> > + clock-names = "pclk", "hclk", "tsu_clk";
> > + phy-mode = "rgmii-id";
> > + cdns,aw2w-max-pipe = /bits/ 8 <8>;
> > + cdns,ar2r-max-pipe = /bits/ 8 <8>;
> > + cdns,use-aw2b-fill;
> > + local-mac-address = [00 00 00 00 00 00];
> > + phy-handle = <&phy1>;
> > + phy-reset-gpios = <&rp1_gpio 32 GPIO_ACTIVE_LOW>;
> > + phy-reset-duration = <5>;
> > +
> > + phy1: ethernet-phy@1 {
> > + reg = <0x1>;
> > + brcm,powerdown-enable;
>
> Undocumented property, and I would like to understand why this needs to be
> specified in the Device Tree? What model of Broadcom Ethernet PHY is being
> used here?
It's a Broadcom BCM5421 transceiver, and that property is intended to support
the optional link-down powersave from DT. It will require slight changes in
drivers/net/phy/broadcom.c too and is not really necessary for minimal support,
so I will drop it in the next iteration.
Many thanks,
Andrea
> --
> Florian
>
