From: Ard Biesheuvel <ardb@xxxxxxxxxx> When paging is enabled, the CR4.PAE and CR4.LA57 control bits cannot be changed, and so they can simply be preserved rather than reason about whether or not they need to be set. CR4.MCE should be preserved unless the kernel was built without CONFIG_X86_MCE, in which case it must be cleared. CR4.PSE should be set explicitly, regardless of whether or not it was set before. CR4.PGE is set explicitly, and then cleared and set again after programming CR3 in order to flush TLB entries based on global translations. This makes the first assignment redundant, and can therefore be omitted. Signed-off-by: Ard Biesheuvel <ardb@xxxxxxxxxx> --- arch/x86/kernel/head_64.S | 24 +++++++------------- 1 file changed, 8 insertions(+), 16 deletions(-) diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S index fb2a98c29094..426f6fdc0075 100644 --- a/arch/x86/kernel/head_64.S +++ b/arch/x86/kernel/head_64.S @@ -185,6 +185,8 @@ SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL) addq $(init_top_pgt - __START_KERNEL_map), %rax 1: + /* Create a mask of CR4 bits to preserve */ + movl $(X86_CR4_PAE | X86_CR4_LA57), %edx #ifdef CONFIG_X86_MCE /* * Preserve CR4.MCE if the kernel will enable #MC support. @@ -193,20 +195,13 @@ SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL) * configured will crash the system regardless of the CR4.MCE value set * here. */ - movq %cr4, %rcx - andl $X86_CR4_MCE, %ecx -#else - movl $0, %ecx + orl $X86_CR4_MCE, %edx #endif + movq %cr4, %rcx + andl %edx, %ecx - /* Enable PAE mode, PSE, PGE and LA57 */ - orl $(X86_CR4_PAE | X86_CR4_PSE | X86_CR4_PGE), %ecx -#ifdef CONFIG_X86_5LEVEL - testb $1, __pgtable_l5_enabled(%rip) - jz 1f - orl $X86_CR4_LA57, %ecx -1: -#endif + /* Even if ignored in long mode, set PSE uniformly on all logical CPUs. */ + btsl $X86_CR4_PSE_BIT, %ecx movq %rcx, %cr4 /* Setup early boot stage 4-/5-level pagetables. */ @@ -226,11 +221,8 @@ SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL) * Do a global TLB flush after the CR3 switch to make sure the TLB * entries from the identity mapping are flushed. */ - movq %cr4, %rcx - movq %rcx, %rax - xorq $X86_CR4_PGE, %rcx + btsl $X86_CR4_PGE_BIT, %ecx movq %rcx, %cr4 - movq %rax, %cr4 /* Ensure I am executing from virtual addresses */ movq $1f, %rax -- 2.44.0.rc0.258.g7320e95886-goog
