Re: Bug 205201 - Booting halts if Dawicontrol DC-2976 UW SCSI board installed, unless RAM size limited to 3500M

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 21 November 2019 at 08:29 am, Christoph Hellwig wrote:
On Sat, Nov 16, 2019 at 08:06:05AM +0100, Christian Zigotzky wrote:
/*
  *  DMA addressing mode.
  *
  *  0 : 32 bit addressing for all chips.
  *  1 : 40 bit addressing when supported by chip.
  *  2 : 64 bit addressing when supported by chip,
  *      limited to 16 segments of 4 GB -> 64 GB max.
  */
#define   SYM_CONF_DMA_ADDRESSING_MODE CONFIG_SCSI_SYM53C8XX_DMA_ADDRESSING_MODE

Cyrus config:

CONFIG_SCSI_SYM53C8XX_DMA_ADDRESSING_MODE=1

I will configure “0 : 32 bit addressing for all chips” for the RC8. Maybe this is the solution.
0 means you are going to do bounce buffering a lot, which seems
generally like a bad idea.

But why are we talking about the sym53c8xx driver now?  The last issue
you reported was about video4linux allocations.

Both drivers have the same problem. They don't work if we have more than 3.5GB RAM. I try to find a solution until your have a good solution. I have already a solution for V4L but I still need one for the sym53c8xx driver.



[Index of Archives]     [Linux Kernel]     [Kernel Newbies]     [x86 Platform Driver]     [Netdev]     [Linux Wireless]     [Netfilter]     [Bugtraq]     [Linux Filesystems]     [Yosemite Discussion]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Device Mapper]

  Powered by Linux