After more experience with the cases where no one the si_code of 0 is used both as a signal specific si_code, and as SI_USER it appears that no one cares about the signal specific si_code case and the good solution is to just fix the architectures by using a different si_code. In none of the conversations has anyone even suggested that anything depends on the signal specific redefinition of SI_USER. There are at least test cases that care when si_code as 0 does not work as si_user. So make things simple and keep the generic code from introducing problems by removing the special casing of TRAP_FIXME and FPE_FIXME. This will ensure the generic case of sending a signal with kill will always set SI_USER and work. The architecture specific, and signal specific overloads that set si_code to 0 will now have problems with signalfd and the 32bit compat versions of siginfo copying. At least until they are fixed. Signed-off-by: "Eric W. Biederman" <ebiederm@xxxxxxxxxxxx> --- kernel/signal.c | 9 --------- 1 file changed, 9 deletions(-) diff --git a/kernel/signal.c b/kernel/signal.c index d56f4d496c89..fc82d2c0918f 100644 --- a/kernel/signal.c +++ b/kernel/signal.c @@ -2835,15 +2835,6 @@ enum siginfo_layout siginfo_layout(int sig, int si_code) layout = SIL_POLL; else if (si_code < 0) layout = SIL_RT; - /* Tests to support buggy kernel ABIs */ -#ifdef TRAP_FIXME - if ((sig == SIGTRAP) && (si_code == TRAP_FIXME)) - layout = SIL_FAULT; -#endif -#ifdef FPE_FIXME - if ((sig == SIGFPE) && (si_code == FPE_FIXME)) - layout = SIL_FAULT; -#endif } return layout; } -- 2.14.1
