The manpage is missing information about the compatibility hack for
5-level paging that went in in 4.14, around commit ee00f4a32a76 ("x86/mm:
Allow userspace have mappings above 47-bit"). Add some information about
that.
While I don't think any hardware supporting this is shipping yet (?), I
think it's useful to try to write a manpage for this API, partly to
figure out how usable that API actually is, and partly because when this
hardware does ship, it'd be nice if distro manpages had information about
how to use it.
Signed-off-by: Jann Horn <jannh@xxxxxxxxxx>
---
This patch goes on top of the patch "[PATCH] mmap.2: fix description of
treatment of the hint" that I just sent, but I'm not sending them in a
series because I want the first one to go in, and I think this one might
be a bit more controversial.
It would be nice if the architecture maintainers and mm folks could have
a look at this and check that what I wrote is right - I only looked at
the source for this, I haven't tried it.
man2/mmap.2 | 15 +++++++++++++++
1 file changed, 15 insertions(+)
diff --git a/man2/mmap.2 b/man2/mmap.2
index 8556bbfeb..977782fa8 100644
--- a/man2/mmap.2
+++ b/man2/mmap.2
@@ -67,6 +67,8 @@ is NULL,
then the kernel chooses the (page-aligned) address
at which to create the mapping;
this is the most portable method of creating a new mapping.
+On Linux, in this case, the kernel may limit the maximum address that can be
+used for allocations to a legacy limit for compatibility reasons.
If
.I addr
is not NULL,
@@ -77,6 +79,19 @@ or equal to the value specified by
and attempt to create the mapping there.
If another mapping already exists there, the kernel picks a new
address, independent of the hint.
+However, if a hint above the architecture's legacy address limit is provided
+(on x86-64: above 0x7ffffffff000, on arm64: above 0x1000000000000, on ppc64 with
+book3s: above 0x7fffffffffff or 0x3fffffffffff, depending on page size), the
+kernel is permitted to allocate mappings beyond the architecture's legacy
+address limit. The availability of such addresses is hardware-dependent.
+Therefore, if you want to be able to use the full virtual address space of
+hardware that supports addresses beyond the legacy range, you need to specify an
+address above that limit; however, for security reasons, you should avoid
+specifying a fixed valid address outside the compatibility range,
+since that would reduce the value of userspace address space layout
+randomization. Therefore, it is recommended to specify an address
+.I beyond
+the end of the userspace address space.
.\" Before Linux 2.6.24, the address was rounded up to the next page
.\" boundary; since 2.6.24, it is rounded down!
The address of the new mapping is returned as the result of the call.
--
2.20.1.791.gb4d0f1c61a-goog
