[PATCH 04/19] thunderbolt: Use bit 31 to check if Firmware CM is running in Tiger Lake

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



In Tiger Lake the Firmware CM is always enabled (so bit 0 is always set)
but it may be in "pass through" mode which means it requires Software CM
instead. This can be determined by checking bit 31 instead.

Signed-off-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
---
 drivers/thunderbolt/icm.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/thunderbolt/icm.c b/drivers/thunderbolt/icm.c
index ffcc8c3459e5..b51fc3f62b1f 100644
--- a/drivers/thunderbolt/icm.c
+++ b/drivers/thunderbolt/icm.c
@@ -1635,11 +1635,14 @@ static void icm_icl_rtd3_veto(struct tb *tb, const struct icm_pkg_header *hdr)
 
 static bool icm_tgl_is_supported(struct tb *tb)
 {
+	u32 val;
+
 	/*
 	 * If the firmware is not running use software CM. This platform
 	 * should fully support both.
 	 */
-	return icm_firmware_running(tb->nhi);
+	val = ioread32(tb->nhi->iobase + REG_FW_STS);
+	return !!(val & REG_FW_STS_NVM_AUTH_DONE);
 }
 
 static void icm_handle_notification(struct work_struct *work)
-- 
2.28.0




[Index of Archives]     [Linux IBM ACPI]     [Linux Power Management]     [Linux Kernel]     [Linux Laptop]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux