Use driver's local data to evaluate the need to run or not to run a
measurement.
Signed-off-by: Andrzej Pietrasiewicz <andrzej.p@xxxxxxxxxxxxx>
---
drivers/thermal/imx_thermal.c | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c
index 9700ae39feb7..c0efa7bc48e2 100644
--- a/drivers/thermal/imx_thermal.c
+++ b/drivers/thermal/imx_thermal.c
@@ -252,10 +252,11 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp)
const struct thermal_soc_data *soc_data = data->socdata;
struct regmap *map = data->tempmon;
unsigned int n_meas;
- bool wait;
+ bool wait, run_measurement;
u32 val;
- if (thermal_zone_device_is_enabled(tz)) {
+ run_measurement = !data->irq_enabled;
+ if (!run_measurement) {
/* Check if a measurement is currently in progress */
regmap_read(map, soc_data->temp_data, &val);
wait = !(val & soc_data->temp_valid_mask);
@@ -282,7 +283,7 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp)
regmap_read(map, soc_data->temp_data, &val);
- if (!thermal_zone_device_is_enabled(tz)) {
+ if (run_measurement) {
regmap_write(map, soc_data->sensor_ctrl + REG_CLR,
soc_data->measure_temp_mask);
regmap_write(map, soc_data->sensor_ctrl + REG_SET,
--
2.17.1
