Re: [net-next PATCH v3 4/5] net: phy: Introduce fwnode_get_phy_id()

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, May 09, 2020 at 01:42:57AM +0200, Andrew Lunn wrote:
> On Fri, May 08, 2020 at 05:48:33PM -0500, Jeremy Linton wrote:
> > Hi,
> > 
> > On 5/8/20 3:27 PM, Andrew Lunn wrote:
> > > > > There is a very small number of devices where the vendor messed up,
> > > > > and did not put valid contents in the ID registers. In such cases, we
> > > > > can read the IDs from device tree. These are then used in exactly the
> > > > > same way as if they were read from the device.
> > > > > 
> > > > 
> > > > Is that the case here?
> > > 
> > > Sorry, I don't understand the question?
> > 
> > I was asking in general, does this machine report the ID's correctly.
> 
> Very likely, it does.
> 
> > The embedded single mac:mdio per nic case seems like the normal case, and
> > most of the existing ACPI described devices are setup that way.
> 
> Somebody in this thread pointed to ACPI patches for the
> MACCHIATOBin. If i remember the hardware correctly, it has 4 Ethernet
> interfaces, and two MDIO bus masters. One of the bus masters can only
> do C22 and the other can only do C45. It is expected that the busses
> are shared, not a nice one to one mapping.
> 
> > But at the same time, that shifts the c22/45 question to the nic
> > driver, where use of a DSD property before instantiating/probing
> > MDIO isn't really a problem if needed.
> 
> This in fact does not help you. The MAC driver has no idea what PHY is
> connected to it. The MAC does not know if it is C22 or C45. It uses
> the phylib abstraction which hides all this. Even if you assume 1:1,
> use phy_find_first(), it will not find a C45 PHY because without
> knowing there is a C45 PHY, we don't scan for it. And we should expect
> C45 PHYs to become more popular in the next few years.

Agree.

NXP's LX2160ARDB platform currently has the following MDIO-PHY connection.

MDIO-1 ==> one 40G PHY, two 1G PHYs(C45), two 10G PHYs(C22)
MDIO-2 ==> one 25G PHY

Both the MDIOs are capable of C45.

There can be other complex use cases as well.
So, it is important to configure MDIO talk both C22 and C45 for different PHYs
connected on the same bus.

Regards
Calvin



[Index of Archives]     [Linux IBM ACPI]     [Linux Power Management]     [Linux Kernel]     [Linux Laptop]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux