thermal/of calls its own ->set_mode() method, so monitor thermal zone
afterwards. This is needed for the DISABLED->ENABLED transition.
Signed-off-by: Andrzej Pietrasiewicz <andrzej.p@xxxxxxxxxxxxx>
---
drivers/thermal/of-thermal.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/thermal/of-thermal.c b/drivers/thermal/of-thermal.c
index 0f1e134e90ea..aa4cbc904c5c 100644
--- a/drivers/thermal/of-thermal.c
+++ b/drivers/thermal/of-thermal.c
@@ -542,8 +542,11 @@ thermal_zone_of_sensor_register(struct device *dev, int sensor_id, void *data,
if (id == sensor_id) {
tzd = thermal_zone_of_add_sensor(child, sensor_np,
data, ops);
- if (!IS_ERR(tzd))
+ if (!IS_ERR(tzd)) {
thermal_zone_device_enable(tzd);
+ thermal_zone_device_update(tzd,
+ THERMAL_EVENT_UNSPECIFIED);
+ }
of_node_put(child);
goto exit;
--
2.17.1
