Hi Robin, Drew,
On 12/19/18 2:18 PM, Andrew Jones wrote:
> On Wed, Dec 19, 2018 at 12:21:35PM +0000, Robin Murphy wrote:
>> On 18/12/2018 18:48, Andrew Jones wrote:
>>> The sum of dmaaddr and size may overflow, particularly considering
>>> there are cases where size will be U64_MAX.
>>
>> Only if the firmware is broken in the first place, though. It would be weird
>> to describe an explicit _DMA range of base=0 and size=U64_MAX, because it's
>> effectively the same as just not having one at all, but it's not strictly
>> illegal. However, since the ACPI System Memory address space is at most
>> 64-bit, anything that would actually overflow here is already describing an
>> impossibility - really, we should probably scream even louder about a
>> firmware bug and reject it entirely, rather than quietly hiding it.
>
> Ah, looking again I see the paths. Either acpi_dma_get_range() returns
> success, in which case base and size are fine, or it returns an EINVAL,
> in which case base=size=0, or it returns ENODEV in which case base is
> zero, so size may be set to U64_MAX by rc_dma_get_range() with no problem.
> The !dev_is_pci(dev) path is also fine since base=0.
So practically putting an explicit memory_address_limit=64 is harmless
as dmaaddr always is 0, right?
In QEMU I intended to update the ACPI code to comply with the rev D
spec. in that case the RC table revision is 1 (rev D) and the
memory_address_limit needs to be filled. If we don't want to restrict
the limit, isn't it the right choice to set 64 here?
Thanks
Eric
>
> While I agree that we should complain when firmware provides bad ACPI
> tables, my understanding of setting iort.memory_address_limit=64 was
> that it simply meant "no limit", regardless of the base. However I now
> see that it won't be used unless base=0. So I don't think we have a
> problem, and we don't even seem to be missing firmware sanity checks.
>
> It might be nice to have a comment explaining this stuff somewhere, but
> otherwise sorry for the noise.
>
> Thanks,
> drew
>
>>
>> Robin.
>>
>>> Signed-off-by: Andrew Jones <drjones@xxxxxxxxxx>
>>> ---
>>> drivers/acpi/arm64/iort.c | 7 ++++++-
>>> 1 file changed, 6 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/drivers/acpi/arm64/iort.c b/drivers/acpi/arm64/iort.c
>>> index 70f4e80b9246..a0f4c157ba5e 100644
>>> --- a/drivers/acpi/arm64/iort.c
>>> +++ b/drivers/acpi/arm64/iort.c
>>> @@ -1002,7 +1002,12 @@ void iort_dma_setup(struct device *dev, u64 *dma_addr, u64 *dma_size)
>>> }
>>> if (!ret) {
>>> - msb = fls64(dmaaddr + size - 1);
>>> + u64 dmaaddr_max = dmaaddr + size - 1;
>>> + if (dmaaddr_max >= dmaaddr)
>>> + msb = fls64(dmaaddr_max);
>>> + else
>>> + msb = 64;
>>> +
>>> /*
>>> * Round-up to the power-of-two mask or set
>>> * the mask to the whole 64-bit address space
>>>
