On Tue, Jul 10, 2018 at 12:43 PM Robin Murphy <robin.murphy@xxxxxxx> wrote:
>
> Whilst the common firmware code invoked by dma_configure() initialises
> devices' DMA masks according to limitations described by the respective
> properties ("dma-ranges" for OF and _DMA/IORT for ACPI), the nature of
> the dma_set_mask() API leads to that information getting lost when
> well-behaved drivers probe and set a 64-bit mask, since in general
> there's no way to tell the difference between a firmware-described mask
> (which should be respected) and whatever default may have come from the
> bus code (which should be replaced outright). This can break DMA on
> systems with certain IOMMU topologies (e.g. [1]) where the IOMMU driver
> only knows its maximum supported address size, not how many of those
> address bits might actually be wired up between any of its input
> interfaces and the associated DMA master devices. Similarly, some PCIe
> root complexes only have a 32-bit native interface on their host bridge,
> which leads to the same DMA-address-truncation problem in systems with a
> larger physical memory map and RAM above 4GB (e.g. [2]).
>
> These patches attempt to deal with this in the simplest way possible by
> generalising the specific quirk for 32-bit bridges into an arbitrary
> mask which can then also be plumbed into the firmware code. In the
> interest of being minimally invasive, I've only included a point fix
> for the IOMMU issue as seen on arm64 - there may be further tweaks
> needed in DMA ops to catch all possible incarnations of this problem,
> but this initial RFC is mostly about the impact beyond the dma-mapping
> subsystem itself.
Couldn't you set and use the device's parent's dma_mask instead. At
least for DT, we should always have a parent device representing the
bus. That would avoid further bloating of struct device.
Rob
--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
