On Wed, Apr 25, 2018 at 11:00:47AM +0200, Rafael J. Wysocki wrote: > On Wednesday, April 25, 2018 9:47:36 AM CEST Johan Hovold wrote: > > On Tue, Apr 24, 2018 at 11:16:38PM +0200, Hans de Goede wrote: > > > Hi, > > > > > > On 24-04-18 19:18, Johan Hovold wrote: > > > > [ Adding some more people on CC. ] > > > > > > > > On Tue, Apr 24, 2018 at 04:29:53PM +0800, Shrirang Bagul wrote: > > > >> On systems using Intel Atom (Baytrail-I) SoC's, slave devices connected on > > > >> HSUART1/2 ports are described by the ACPI BIOS as virtual hardware using > > > >> HID's INT3511/INT3512 [1]. > > > >> > > > >> As a consequence, HW manufacturers have complete freedom to install any > > > >> devices on-board as long as they can be accessed over serial tty > > > >> interface. Once such device is Dell Edge 3002 IoT Gateway which sports > > > >> ZigBee & GPS devices on the HS-UART ports 1 & 2 respectively. > > > >> > > > >> In kernels before the introduction of 'Serial Device Bus (serdev)' > > > >> subsystem, these devices were accessible using /dev/ttySx nodes. But, > > > >> kernels since 4.15 can no longer do so. > > > >> > > > >> Post 4.15, with CONFIG_SERIAL_DEV_BUS=y, serdev port controller driver > > > >> handles the enumeration for the slaves connected on these ports. Also, > > > >> /dev/ttySx device nodes for these ports are no longer exposed to the > > > >> userspace. > > > >> > > > >> This patch implements a new driver which binds to the ACPI serdev slaves > > > >> enumerated by the serdev port controller and exposes /dev/ttyHSx device > > > >> nodes which the userspace applications can use. Otherwise, upgrades to 4.15 > > > >> or higher kernels would certainly render these devices unusable. > > > >> > > > >> Considering serdev is new and evolving, this is one approach to solving > > > >> the problem at hand. An obvious drawback is the change in the tty device > > > >> node name from ttySx => ttyHSx, which means userspace applications have to > > > >> be modified (I know that this is strongly discouraged). For the same > > > >> reason, I am submitting these patches as RFC. > > > >> > > > >> If there are other/better ways of solving this or improving on the > > > >> proposed solution, that will be most helpful. > > > > > > > > Yeah, I don't think this is the right solution to this problem. It seems > > > > we need to blacklist (or maybe even use whitelists) ACPI-ids until there > > > > are drivers for the slave devices that would otherwise be claimed by > > > > serdev. > > > > > > FWIW I've been using this patch for a while for realtek UART attached bluetooth: > > > https://github.com/jwrdegoede/linux-sunxi/commit/bc904e3703940600ca66c65fcdb0a8cb01dff55d > > > which is a gross hack. > > > > > > If we're going to do a whitelist for this, it better support some sort of > > > wildcards as there are a LOT of BCM2E?? devices which need to be on the > > > whitelist. I think a blacklist would actually be better though, this also > > > documents which devices are lacking a proper kernel (where applicable). > > > > Yeah, you guys know the ACPI space better than I do. I just fear that > > if we go with the blacklist approach, we'll be playing a whack-a-mole > > with this for a long time when people start upgrading there systems to > > 4.15 and discover that their serial ports are gone. > > > > Since this would qualify as a severe regression, me may need to consider > > adding a serdev whitelist for every ACPI id we add to a serdev driver > > instead. > > OK, so let's have the ACPI discussion on linux-acpi pretty please. Oh, sorry, I forgot to add linux-acpi. > Could this be resent with a CC to linux-acpi for some more complete > context? Fortunately, I think the relevant context is still there above. In short, when we added ACPI support to serdev, serdev started claiming all slave devices to UARTs that happen to described by ACPI. Regardless of whether there's a kernel driver for them or not. This means that serial ports (/dev/ttySn) will simply start disappearing on such systems when updating to 4.15 unless we act somehow (blacklist or whitelist). Thanks, Johan -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
