This patchset supports the IPMI-bt device attached to the Low-Pin-Count interface implemented on Hisilicon Hip06/Hip07 SoC. ----------- | LPC host| | | ----------- | _____________V_______________LPC | | V V ------------ | BT(ipmi)| ------------ When master accesses those peripherals beneath the Hip06/Hip07 LPC, a specific LPC driver is needed to make LPC host generate the standard LPC I/O cycles with the target peripherals'I/O port addresses. But on curent arm64 world, there is no real I/O accesses. All the I/O operations through in/out accessors are based on MMIO ranges; on Hip06/Hip07 LPC the I/O accesses are performed through driver specific accessors rather than MMIO. To solve this issue and keep the relevant existing peripherals' drivers untouched, this patchset: - introduces a generic I/O space management framework, logical PIO, to support I/O operations on host controllers operating either on MMIO buses or on buses requiring specific driver I/O accessors; - redefines the in/out accessors to provide a unified interface for both MMIO and driver specific I/O operations. Using logical PIO, th call of in/out() from the host children drivers, such as ipmi-si, will be redirected to the corresponding device-specific I/O hooks to perform the I/O accesses. Based on this patch-set, all the I/O accesses to Hip06/Hip07 LPC peripherals can be supported without any changes on the existing ipmi-si driver. The whole patchset has been tested on Hip07 D05 board both using DTB and ACPI. Differences to v16: - Add patch to rename acpi_is_serial_bus_slave() Note: Could not rebase on recent linux-next as either build broken or fails to boot. Differences to v15: - addressed further coding style comments in LLDD and logic PIO code from Andy - rebased to linux next 20180302 Differences to v14: - addressed coding style comments from Andy - applied tags from Rafael, Andy, and Dann - rebased to linux next 20180223 (had to fix locally arm64 build issue) Differences to v13: - dropped ACPI scan handler and added patch to not enumerate children of indirect IO hosts in ACPI code - tidied up logic_pio.c a bit for kerneldoc and made some APIs clearer to understand - tided (and simplified) hisi_lpc.c and added new ACPI probe code (same as previous ACPI scan handler code, so comments from Rafael and Andy included) - reinstated PCI range upper limit check in pci_pio_to_address() - dropped Dann Frazier's "tested-by" tag in light of changes - rebase to linuxnext 20180219 (had to fix locally arm64 build issue) Differences to v12: - Addressed ACPI comments from Rafael and Andy, including: - added SPDX license identifiers (other new files in the series got this also) - fixed style issues, like superflous newlines and symbol naming - add fuller acpi_indirectio.c patch commit message - dropped acpi_indirectio_host_data (author's decision) to simplify - added Rob Herring's tag - rebase to linux-next 20180212 Differences to v11: - fixed build errors for i386, m68k, and tile - added a comment in LPC driver commit log why we set the kernel config as bool - some tidying logic_pio code Differences to v10: - dropped CONFIG_LOGIC_PIO. Reason is that CONFIG_PCI depends on this, and CONFIG_PCI is a per-arch CONFIG. So we would require all arch's kconfig to select this. - Addressed Dann Frazier's comments on LPC driver, and sopme other cleanup - Moved logic_pio.h to be included in generic asm io.h - Fixed ACPI indirect IO host setup to handle >1 child - Relocated ACPI indirect IO host setup code to drivers/acpi - Rebased to linux next-20180118 Changes from v9: - patch 2 has been split into 3 patches according to Bjorn comments on v9 thread - patch 1 has been reworked accordign to Bjorn comments on v9 - now logic_pio_trans_hwaddr() has a sanity check to make sure the resource size fits into the assigned range - in patch 5 the MFD framework has been used to probe the LPC children according to the suggestion from Mika Westerberg - Maintaner has changed to Huawei Linuxarm mailing list Changes from v8: - Simplified LIB IO framewrok - Moved INDIRECT PIO ACPI framework under acpi/arm64 - Renamed occurrences of "lib io" and "indirect io" to "lib pio" and "indirect pio" to keep the patchset nomenclature consistent - Removed Alignment reuqirements - Moved LPC specific code out of ACPI common framework - Now PIO indirect HW ranges can overlap - Changed HiSilicon LPC driver maintainer (Gabriele Paoloni now) and split maintaner file modifications in a separate commit - Removed the commit with the DT nodes support for hip06 and hip07 (to be pushed separately) - Added a checking on ioport_map() not to break that function as Arnd points out in V7 review thread; - fixed the compile issues on alpha, m68k; Changes from V7: - Based on Arnd's comment, rename the LIBIO as LOGIC_PIO; - Improved the mapping process in LOGIC_PIO to gain better efficiency when redirecting the I/O accesses to right device driver; - To reduce the impact on PCI MMIO to a minimum, add a new CONFIG_INDIRECT_PIO for indirect-IO hosts/devices; - Added a new ACPI handler for indirect-IO hosts/devices; - Fixed the compile issues on V6; Changes from V6: - According to the comments from Bjorn and Alex, merge PCI IO and indirect-IO into a generic I/O space management, LIBIO; - Adopted the '_DEP' to replace the platform bus notifier. In this way, we can ensure the LPC peripherals' I/O resources had been translated to logical IO before the LPC peripheral enumeration; - Replaced the rwlock with rcu list based on Alex's suggestion; - Applied relaxed write/read to LPC driver; - Some bugs fixing and some optimazations based on the comments of V6; Changes from V5: - Made the extio driver more generic and locate in lib/; - Supported multiple indirect-IO bus instances; - Extended the pci_register_io_range() to support indirect-IO, then dropped the I/O reservation used in previous patchset; - Reimplemented the ACPI LPC support; - Fixed some bugs, including the compile error on other archs, the module building failure found by Ming Lei, etc; Changes from V4: - Some revises based on the comments from Bjorn, Rob on V4; - Fixed the compile error on some platforms, such as openrisc; Changes from V3: - UART support deferred to a separate patchset; This patchset only support ipmi device under LPC; - LPC bus I/O range is fixed to 0 ~ (PCIBIOS_MIN_IO - 1), which is separeted from PCI/PCIE PIO space; - Based on Arnd's remarks, removed the ranges property from Hip06 lpc dts and added a new fixup function, of_isa_indirect_io(), to get the I/O address directly from LPC dts configurations; - Support in(w,l)/out(w,l) for Hip06 lpc I/O; - Decouple the header file dependency on the gerenic io.h by defining in/out as normal functions in c file; - removed unused macro definitions in the LPC driver; Changes from V2: - Support the PIO retrieval from the linux PIO generated by pci_address_to_pio. This method replace the 4K PIO reservation in V2; - Support the flat-tree earlycon; - Some revises based on Arnd's remarks; - Make sure the linux PIO range allocated to Hip06 LPC peripherals starts from non-ZERO; Changes from V1: - Support the ACPI LPC device; - Optimize the dts LPC driver in ISA compatible mode; - Reserve the IO range below 4K in avoid the possible conflict with PCI host IO ranges; - Support the LPC uart and relevant earlycon; V16 thread here: https://lkml.org/lkml/2018/2/26/584 V15 thread here: https://lkml.org/lkml/2018/2/26/584 V14 thread here: https://lkml.org/lkml/2018/2/19/460 V13 thread here: https://lkml.org/lkml/2018/2/13/744 V12 thread here: https://lkml.org/lkml/2018/1/23/508 V11 thread here: https://lkml.org/lkml/2018/1/21/38 V10 thread here: https://lkml.org/lkml/2017/10/27/465 V9 thread here: https://lkml.org/lkml/2017/5/25/263 V8 thread here: https://lkml.org/lkml/2017/3/30/619 V7 thread here: https://lkml.org/lkml/2017/3/12/279 v6 thread here: https://lkml.org/lkml/2017/1/24/25 v5 thread here: https://lkml.org/lkml/2016/11/7/955 v4 thread here: https://lkml.org/lkml/2016/10/20/149 v3 thread here: https://lkml.org/lkml/2016/9/14/326 v2 thread here: https://lkml.org/lkml/2016/9/7/356 v1 thread here: https://lkml.org/lkml/2015/12/29/154 Gabriele Paoloni (2): PCI: Remove unused __weak attribute in pci_register_io_range() PCI: Add fwnode handler as input param of pci_register_io_range() John Garry (4): ACPI / scan: rename acpi_is_serial_bus_slave() to widen use ACPI / scan: do not enumerate Indirect IO host children HISI LPC: Add ACPI support MAINTAINERS: Add maintainer for HiSilicon LPC driver Zhichang Yuan (4): LIB: Introduce a generic PIO mapping method PCI: Apply the new generic I/O management on PCI IO hosts OF: Add missing I/O range exception for indirect-IO devices HISI LPC: Support the LPC host on Hip06/Hip07 with DT bindings .../arm/hisilicon/hisilicon-low-pin-count.txt | 33 ++ MAINTAINERS | 7 + drivers/acpi/pci_root.c | 8 +- drivers/acpi/scan.c | 33 +- drivers/bus/Kconfig | 8 + drivers/bus/Makefile | 2 + drivers/bus/hisi_lpc.c | 623 +++++++++++++++++++++ drivers/of/address.c | 96 +++- drivers/pci/pci.c | 95 +--- include/acpi/acpi_bus.h | 2 +- include/asm-generic/io.h | 4 +- include/linux/logic_pio.h | 124 ++++ include/linux/pci.h | 3 +- lib/Kconfig | 15 + lib/Makefile | 2 + lib/logic_pio.c | 282 ++++++++++ 16 files changed, 1229 insertions(+), 108 deletions(-) create mode 100644 Documentation/devicetree/bindings/arm/hisilicon/hisilicon-low-pin-count.txt create mode 100644 drivers/bus/hisi_lpc.c create mode 100644 include/linux/logic_pio.h create mode 100644 lib/logic_pio.c -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html