Hi Jeremy, > -----Original Message----- > From: Jeremy Linton <jeremy.linton@xxxxxxx> > Sent: Thursday, March 1, 2018 3:36 AM > To: linux-acpi@xxxxxxxxxxxxxxx > Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx; sudeep.holla@xxxxxxx; > lorenzo.pieralisi@xxxxxxx; hanjun.guo@xxxxxxxxxx; rjw@xxxxxxxxxxxxx; > will.deacon@xxxxxxx; catalin.marinas@xxxxxxx; > gregkh@xxxxxxxxxxxxxxxxxxx; mark.rutland@xxxxxxx; linux- > kernel@xxxxxxxxxxxxxxx; linux-riscv@xxxxxxxxxxxxxxxxxxx; > wangxiongfeng2@xxxxxxxxxx; vkilari@xxxxxxxxxxxxxx; ahs3@xxxxxxxxxx; > dietmar.eggemann@xxxxxxx; morten.rasmussen@xxxxxxx; > palmer@xxxxxxxxxx; lenb@xxxxxxxxxx; john.garry@xxxxxxxxxx; > austinwc@xxxxxxxxxxxxxx; tnowicki@xxxxxxxxxxxxxxxxxx; Jeremy Linton > <jeremy.linton@xxxxxxx> > Subject: [PATCH v7 00/13] Support PPTT for ARM64 > > ACPI 6.2 adds the Processor Properties Topology Table (PPTT), which is used to > describe the processor and cache topology. Ideally it is used to extend/override > information provided by the hardware, but right now ARM64 is entirely > dependent on firmware provided tables. > > This patch parses the table for the cache topology and CPU topology. > When we enable ACPI/PPTT for arm64 we map the physical_id to the PPTT > node flagged as the physical package by the firmware. > This results in topologies that match what the remainder of the system expects. > To avoid inverted scheduler domains we then set the MC domain equal to the > largest cache within the socket below the NUMA domain. > > For example on juno: > [root@mammon-juno-rh topology]# lstopo-no-graphics > Package L#0 > L2 L#0 (1024KB) > L1d L#0 (32KB) + L1i L#0 (32KB) + Core L#0 + PU L#0 (P#0) > L1d L#1 (32KB) + L1i L#1 (32KB) + Core L#1 + PU L#1 (P#1) > L1d L#2 (32KB) + L1i L#2 (32KB) + Core L#2 + PU L#2 (P#2) > L1d L#3 (32KB) + L1i L#3 (32KB) + Core L#3 + PU L#3 (P#3) > L2 L#1 (2048KB) > L1d L#4 (32KB) + L1i L#4 (48KB) + Core L#4 + PU L#4 (P#4) > L1d L#5 (32KB) + L1i L#5 (48KB) + Core L#5 + PU L#5 (P#5) > HostBridge L#0 > PCIBridge > PCIBridge > PCIBridge > PCI 1095:3132 > Block(Disk) L#0 "sda" > PCIBridge > PCI 1002:68f9 > GPU L#1 "renderD128" > GPU L#2 "card0" > GPU L#3 "controlD64" > PCIBridge > PCI 11ab:4380 > Net L#4 "enp8s0" > > Git tree at: > http://linux-arm.org/git?p=linux-jlinton.git > branch: pptt_v7 Tested this series and looks good Tested by: Vijaya Kumar K <vkilari@xxxxxxxxxxxxxx> > > v6->v7: > Add additional patch to use the last cache level within the NUMA > or socket as the MC domain. This assures the MC domain is > equal or smaller than the DIE. > > Various formatting/etc review comments. > > Rebase to 4.16rc2 > > v5->v6: > Add additional patches which re-factor how the initial DT code sets > up the cacheinfo structure so that its not as dependent on the > of_node stored in that tree. Once that is done we rename it > for use with the ACPI code. > > Additionally there were a fair number of minor name/location/etc > tweaks scattered about made in response to review comments. > > v4->v5: > Update the cache type from NOCACHE to UNIFIED when all the cache > attributes we update are valid. This fixes a problem where caches > which are entirely created by the PPTT don't show up in lstopo. > > Give the PPTT its own firmware_node in the cache structure instead of > sharing it with the of_node. > > Move some pieces around between patches. > > (see previous cover letters for futher changes) > > Jeremy Linton (13): > drivers: base: cacheinfo: move cache_setup_of_node() > drivers: base: cacheinfo: setup DT cache properties early > cacheinfo: rename of_node to fw_token > arm64/acpi: Create arch specific cpu to acpi id helper > ACPI/PPTT: Add Processor Properties Topology Table parsing > ACPI: Enable PPTT support on ARM64 > drivers: base cacheinfo: Add support for ACPI based firmware tables > arm64: Add support for ACPI based firmware tables > ACPI/PPTT: Add topology parsing code > arm64: topology: rename cluster_id > arm64: topology: enable ACPI/PPTT based CPU topology > ACPI: Add PPTT to injectable table list > arm64: topology: divorce MC scheduling domain from core_siblings > > arch/arm64/Kconfig | 1 + > arch/arm64/include/asm/acpi.h | 4 + > arch/arm64/include/asm/topology.h | 9 +- > arch/arm64/kernel/cacheinfo.c | 15 +- > arch/arm64/kernel/topology.c | 132 +++++++- > arch/riscv/kernel/cacheinfo.c | 1 - > drivers/acpi/Kconfig | 3 + > drivers/acpi/Makefile | 1 + > drivers/acpi/pptt.c | 642 > ++++++++++++++++++++++++++++++++++++++ > drivers/acpi/tables.c | 2 +- > drivers/base/cacheinfo.c | 157 +++++----- > include/linux/acpi.h | 4 + > include/linux/cacheinfo.h | 17 +- > 13 files changed, 882 insertions(+), 106 deletions(-) create mode 100644 > drivers/acpi/pptt.c > > -- > 2.13.6 -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
