Hi,
On 05-10-17 12:45, Marcel Holtmann wrote:
Hi Hans,
Make the serdev driver use struct bcm_device as its driver data and share
all the pm / GPIO / IRQ related code paths with the platform driver.
After this commit the 2 drivers are in essence the same and the serdev
driver interface can be used for all ACPI enumerated HCI UARTs.
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
drivers/bluetooth/hci_bcm.c | 118 +++++++++++++++++++++++++-------------------
1 file changed, 68 insertions(+), 50 deletions(-)
all 9 patches have been applied to bluetooth-next tree.
Excellent, thank you!
So I guess this means we can also move forward with getting
the 2 patches from Frédéric Danis merged ? There is a bit
of a bisect-ability problem there, if the acpi pull-req
gets merged first then uart attached bcm bt will stop
working until the bluetooth subsys is also merged.
But I don't think this will impact a lot of users
(also given the need for a manual btattach so far),
so I don't think this is a big problem... ?
Regards,
Hans
--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
