On 17.05.17 17:04:24, Lorenzo Pieralisi wrote: > On Wed, May 17, 2017 at 04:35:58PM +0200, Robert Richter wrote: > > On 17.05.17 14:46:54, Lorenzo Pieralisi wrote: > > > > > More explicitly, I think the whole series should work also with the diff > > > below applied on top of it. Side note: for consistency, I do not think > > > that adding a DT counterpart to pci_bus_find_numa_node() would hurt. > > > > > > Thanks ! > > > Lorenzo > > > > > > -- >8 -- > > > diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c > > > index 76c089f..cf0692c 100644 > > > --- a/drivers/pci/probe.c > > > +++ b/drivers/pci/probe.c > > > @@ -862,7 +862,7 @@ static struct pci_bus *pci_alloc_child_bus(struct pci_bus *parent, > > > */ > > > child->dev.class = &pcibus_class; > > > dev_set_name(&child->dev, "%04x:%02x", pci_domain_nr(child), busnr); > > > - set_dev_node(&child->dev, dev_to_node(&parent->dev)); > > > + > > > > Hmm, in device_add() there is already: > > > > /* use parent numa_node */ > > if (parent && (dev_to_node(dev) == NUMA_NO_NODE)) > > set_dev_node(dev, dev_to_node(parent)); > > > > So there are cases where the device has a different node than the > > parent. I am not sure if we can assume for pci that it maps always. > > > > And since device_add() is called later anyway, the above change might > > not necessary at all. > > That's why I _removed_ the set_dev_node() in the diff above (that applies > to patch (2)), I do not think it is a) correct and b) necessary to > propagate the NUMA node from bus to a child bus given that device_add() > takes care of that already. Ah, right, you removed it instead. > > I should post a v3 (with the diff above applied) so that we are all on > the same page and we can test it. > > > But at least we must assign the node id to the > > bridge, which is the parent. Maybe just have in > > acpi_pci_root_create(): > > > > bridge = get_device(bus->bridge); > > adev = to_acpi_device_node(bridge->fwnode); > > set_dev_node(bridge, acpi_get_node(adev->handle)); > > I do not think that's enough, I need to check again but I think that > also the bus->dev should have its NUMA node set for things to work (and > allow the NUMA node to propagate correctly through device_add()) > otherwise pcibus_to_node() would fail for devices sitting on the root > bus, right ? Yeah, maybe another hop is in between and the node id for bus->dev is used. Which need to be set then. > > I will check again and post v3 shortly. Thanks, -Robert -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
