On Mon, May 2, 2016 at 3:12 AM, Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx> wrote: > On Fri, Apr 29, 2016 at 06:13:52PM -0700, Andy Lutomirski wrote: >> A question, though: there's nothing that keeps i801_access from being >> called in between consecutive ACPI accesses. Could this confuse the >> ASL code? Would it be helpful if i801_access were to save away the >> old register state and restore it when it's done in the event that an >> opregion access has been seen so that the ASL-configured state doesn't >> get stomped on? > > Looking at those ASL methods of Lenovo Yoga 900 for example they seem to > initialize the hardware, do the transaction and cleanup in one go. > That's also what the i2c-i801.c driver is doing as far as I can say. So > in that sense they should not mess with each other. > Is your locking actually sufficient to get that right? You're taking acpi_lock, which is private to the driver, so you're only holding it during actual opregion access AFAICT. That means that, if one thread is in the ACPI interpreter in one of these blocks and another thread is in the driver, they could still interleave their accesses. Am I missing something? > Of course this all breaks if the ASL code expects the state to survive > between transactions. > >> Also, what happens if i801_access happens while the i801 master is >> busy with an ASL-initiated transaction? Will it wait for the >> transaction to finish? > > Yes, it should since ->acpi_lock is taken by i801_acpi_io_handler(). But i801_acpi_io_handler has no concept of a transaction AFAICT. > >> If this is a problem, an alternative approach might be to virtualize >> the registers as seen by ACPI and to only load them into the real >> registers when a transaction starts. >> >> Also, what happens if the opregion is declared globally instead of in >> the scope of the ACPI companion? Does that happen? If so, it might >> make sense to deny loading the driver unless in lax mode. > > I don't know if that happens but it is certainly possible. > > Actually reading ACPI 6.1 spec again, chapter 5.5.2.4.3 says this: > > If a platform uses a PCI BAR Target operation region, an ACPI OS will > not load a native device driver for the associated PCI function. For > example, if any of the BARs in a PCI function are associated with a PCI > BAR Target operation region, then the OS will assume that the PCI > function is to be entirely under the control of the ACPI system > firmware. No driver will be loaded. > > So what we are currently doing (preventing the driver from loading) is > the right thing to do according the above. Maybe we can change that > warning into debug/info message instead? Is there a way to ask the ACPI core to tell you the scope of the conflict? This is more a question for Rafael and the ACPI folks: this patch installs an io handler for a region in the scope of the ACPI companion of the device, but what if the ASL code does IO using an opregion declared outside the scope of the device? Or is the opregion handler for memory actually global? Given that this seems to be purely hypothetical, this may not be a big deal. --Andy -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
