On Fri, Jan 15, 2016 at 12:12:31PM +0000, Graeme Gregory wrote: > On Thu, Jan 14, 2016 at 09:24:41AM -0500, Mark Salter wrote: > > On Thu, 2016-01-14 at 14:15 +0000, Graeme Gregory wrote: > > > On Thu, Jan 14, 2016 at 09:01:40AM -0500, Mark Salter wrote: > > > > On Thu, 2016-01-14 at 13:44 +0000, Graeme Gregory wrote: > > > > > On Wed, Jan 13, 2016 at 02:20:46PM +0100, Tomasz Nowicki wrote: > > > > > > From the functionality point of view this series might be split into the > > > > > > following logic parts: > > > > > > 1. Make MMCONFIG code arch-agnostic which allows all architectures to collect > > > > > > PCI config regions and used when necessary. > > > > > > 2. Move non-arch specific bits to the core code. > > > > > > 3. Use MMCONFIG code and implement generic ACPI based PCI host controller driver. > > > > > > 4. Enable above driver on ARM64 > > > > > > > > > > > > Patches has been built on top of 4.4 and can be found here: > > > > > > git@xxxxxxxxxx:semihalf-nowicki-tomasz/linux.git (pci-acpi-v3) > > > > > > > > > > > > NOTE, this patch set depends on Matthew's patches: > > > > > > http://www.spinics.net/lists/linux-pci/msg45950.html > > > > > > https://github.com/Vality/linux/tree/pci-fixes > > > > > > > > > > > > This has been tested on Cavium ThunderX server and QEMU. > > > > > > Any help in reviewing and testing is very appreciated. > > > > > > > > > > I have tested this on my AMD Overdrive so > > > > > > > > > > Tested-by: Graeme Gregory <graeme.gregory@xxxxxxxxxx> > > > > > > > > > > But to actually get my r8169 network card working I also need the > > > > > following patch. > > > > > > > > > > diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c > > > > > index 2fbf840..40e24e2 100644 > > > > > --- a/drivers/pci/probe.c > > > > > +++ b/drivers/pci/probe.c > > > > > @@ -1717,7 +1717,7 @@ void pci_device_add(struct pci_dev *dev, struct pci_bus *bus) > > > > > set_dev_node(&dev->dev, pcibus_to_node(bus)); > > > > > dev->dev.dma_mask = &dev->dma_mask; > > > > > dev->dev.dma_parms = &dev->dma_parms; > > > > > - dev->dev.coherent_dma_mask = 0xffffffffull; > > > > > + dev->dev.coherent_dma_mask = DMA_BIT_MASK(64); > > > > > pci_dma_configure(dev); > > > > > > > > > > pci_set_dma_max_seg_size(dev, 65536); > > > > > > > > > > I suspect we need to set coherent_dma_mask somewhere in the platform but I do > > > > > not know where this should happen. Hopefully an ARM64 expert can help. > > > > > > > > I've run into a number of cards which don't work on some arm64 machines where there are > > > > no DMA address below 4G. For the realtek card you can use r8169.use_dac=1 on the cmdline > > > > to get it to work. > > > > > > > I need r8169.use_dac=1 and this patch to get card to work. > > > > > > > Hmm. I didn't need a patch in the past but I don't think I've used that card with > > this patch series. I will try that when I get a chance... > > > > From my previous debugging on this issue I was getting an address bigger > than 32bits. As r8169 is a whole range of chips are guess they are not > all equal? > > I can stick debug stuff in if someone tells me where to put them. > After some private debugging with Mark it turned out that the difference between our configurations was I did not have. CONFIG_DMA_CMA=y With this enabled then the card works without coherent mask hack. Thanks Graeme -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html