On Thu, Jun 18, 2015 at 11:36:08PM +0100, Al Stone wrote: > For those parts of the arm64 ACPI code that need to check GICC subtables > in the MADT, use the new BAD_MADT_GICC_ENTRY macro instead of the previous > BAD_MADT_ENTRY. The new macro takes into account differences in the size > of the GICC subtable that the old macro did not; this caused failures even > though the subtable entries are valid. > > Signed-off-by: Al Stone <al.stone@xxxxxxxxxx> > --- > arch/arm64/kernel/smp.c | 2 +- > drivers/irqchip/irq-gic.c | 2 +- > 2 files changed, 2 insertions(+), 2 deletions(-) Acked-by: Will Deacon <will.deacon@xxxxxxx> Good to see this stuff is holding up so well... Will > diff --git a/arch/arm64/kernel/smp.c b/arch/arm64/kernel/smp.c > index 4b2121b..80d5984 100644 > --- a/arch/arm64/kernel/smp.c > +++ b/arch/arm64/kernel/smp.c > @@ -438,7 +438,7 @@ acpi_parse_gic_cpu_interface(struct acpi_subtable_header *header, > struct acpi_madt_generic_interrupt *processor; > > processor = (struct acpi_madt_generic_interrupt *)header; > - if (BAD_MADT_ENTRY(processor, end)) > + if (BAD_MADT_GICC_ENTRY(processor, end)) > return -EINVAL; > > acpi_table_print_madt_entry(header); > diff --git a/drivers/irqchip/irq-gic.c b/drivers/irqchip/irq-gic.c > index 8d7e1c8..4dd8826 100644 > --- a/drivers/irqchip/irq-gic.c > +++ b/drivers/irqchip/irq-gic.c > @@ -1055,7 +1055,7 @@ gic_acpi_parse_madt_cpu(struct acpi_subtable_header *header, > > processor = (struct acpi_madt_generic_interrupt *)header; > > - if (BAD_MADT_ENTRY(processor, end)) > + if (BAD_MADT_GICC_ENTRY(processor, end)) > return -EINVAL; > > /* > -- > 2.4.0 > -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html