yakui_zhao wrote:
Very good patch.
Do you have the hardware on which the dedicated power source is
required by the serial port(PnP device) in your hand?
Yes, I have an IBM ThinkPad 600E. I need this patch in order to
be able receive accurate time using a DCF77 receiver attached
to the serial port.
[snip]
- if (ACPI_FAILURE(status))
+ if (ACPI_FAILURE(acpi_set_current_resources(handle, &buffer)))
ret = -EINVAL;
+ else if (acpi_bus_power_manageable(handle))
+ ret = acpi_bus_set_power(handle, ACPI_STATE_D0);
How about changing the power state before calling _SRS object?
I recall reading something in the ACPI spec that says that the power
needs to be set after the device was enabled. But the main driver
for this order (_SRS followed by _PS0) is the symmetry to the required
_PS3 followed by _DIS (according to the spec).
[snip]
--- Witold
--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
