Remove CONFIG_ACPI_SYSTEM. It was always set the same as CONFIG_ACPI, and it had no menu label, so there was no way to set it to anything other than "y". Some things under CONFIG_ACPI_SYSTEM (acpi_irq_handled, acpi_os_gpe_count(), event_is_open, register_acpi_notifier(), etc.) are used unconditionally by the CA, the OSPM, and drivers, so we depend on them always being present. Signed-off-by: Bjorn Helgaas <bjorn.helgaas@xxxxxx> --- drivers/acpi/Kconfig | 7 ------- drivers/acpi/Makefile | 2 +- 2 files changed, 1 insertions(+), 8 deletions(-) diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig index a7799a9..8a851d0 100644 --- a/drivers/acpi/Kconfig +++ b/drivers/acpi/Kconfig @@ -254,13 +254,6 @@ config ACPI_PCI_SLOT help you correlate PCI bus addresses with the physical geography of your slots. If you are unsure, say N. -config ACPI_SYSTEM - bool - default y - help - This driver will enable your system to shut down using ACPI, and - dump your ACPI DSDT table using /proc/acpi/dsdt. - config X86_PM_TIMER bool "Power Management Timer Support" if EMBEDDED depends on X86 diff --git a/drivers/acpi/Makefile b/drivers/acpi/Makefile index 65d90c7..b130ea0 100644 --- a/drivers/acpi/Makefile +++ b/drivers/acpi/Makefile @@ -52,7 +52,7 @@ obj-$(CONFIG_ACPI_PROCESSOR) += processor.o obj-$(CONFIG_ACPI_CONTAINER) += container.o obj-$(CONFIG_ACPI_THERMAL) += thermal.o obj-y += power.o -obj-$(CONFIG_ACPI_SYSTEM) += system.o event.o +obj-y += system.o event.o obj-$(CONFIG_ACPI_DEBUG) += debug.o obj-$(CONFIG_ACPI_NUMA) += numa.o obj-$(CONFIG_ACPI_HOTPLUG_MEMORY) += acpi_memhotplug.o -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
