From: Alexey Starikovskiy <aystarik@xxxxxxxxx>
ACPI battery interface reports its state either in mW or in mA, and
discharge rate in your case is reported in mW. power_supply interface
does not have such a parameter, so current_now parameter is used
for all cases. But in case of mW, reported discharge should
be converted into mA.
Signed-off-by: Alexey Starikovskiy <astarikovskiy@xxxxxxx>
Tested-by: Ferenc Wagner <wferi@xxxxxxx>
Signed-off-by: Len Brown <len.brown@xxxxxxxxx>
---
drivers/acpi/battery.c | 9 +++++++++
1 files changed, 9 insertions(+), 0 deletions(-)
diff --git a/drivers/acpi/battery.c b/drivers/acpi/battery.c
index 1423b0c..a0a178d 100644
--- a/drivers/acpi/battery.c
+++ b/drivers/acpi/battery.c
@@ -174,6 +174,15 @@ static int acpi_battery_get_property(struct power_supply *psy,
break;
case POWER_SUPPLY_PROP_CURRENT_NOW:
val->intval = battery->current_now * 1000;
+ /* if power units are mW, convert to mA by
+ dividing by current voltage (mV/1000) */
+ if (!battery->power_unit) {
+ if (battery->voltage_now) {
+ val->intval /= battery->voltage_now;
+ val->intval *= 1000;
+ } else
+ val->intval = -1;
+ }
break;
case POWER_SUPPLY_PROP_CHARGE_FULL_DESIGN:
case POWER_SUPPLY_PROP_ENERGY_FULL_DESIGN:
--
1.5.6.5
--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
