On Wed, Dec 13, 2023 at 7:27 PM Mario Limonciello
<mario.limonciello@xxxxxxx> wrote:
>
> When a system is being powered off it's important that PCIe ports
> have been put into D3cold as there is no other software to turn
> off the devices at S5.
>
> If PCIe ports are left in D0 then any GPIOs toggled by the ACPI
> power resources may be left enabled and devices may consume excess
> power.
Isn't that a platform firmware issue?
It is the responsibility of the platform firmware to properly put the
platform into S5, including power removal from devices that are not
armed for power-on.
> Cc: mpearson-lenovo@xxxxxxxxx
> Signed-off-by: Mario Limonciello <mario.limonciello@xxxxxxx>
> ---
> drivers/pci/pcie/portdrv.c | 11 ++++++++---
> 1 file changed, 8 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/pci/pcie/portdrv.c b/drivers/pci/pcie/portdrv.c
> index 14a4b89a3b83..08238680c481 100644
> --- a/drivers/pci/pcie/portdrv.c
> +++ b/drivers/pci/pcie/portdrv.c
> @@ -734,9 +734,14 @@ static void pcie_portdrv_remove(struct pci_dev *dev)
> static void pcie_portdrv_shutdown(struct pci_dev *dev)
> {
> if (pci_bridge_d3_possible(dev)) {
> - pm_runtime_forbid(&dev->dev);
> - pm_runtime_get_noresume(&dev->dev);
> - pm_runtime_dont_use_autosuspend(&dev->dev);
> + /* whole hierarchy goes into a low power state for S5 */
> + if (system_state == SYSTEM_POWER_OFF) {
> + pci_set_power_state(dev, PCI_D3cold);
> + } else {
> + pm_runtime_forbid(&dev->dev);
> + pm_runtime_get_noresume(&dev->dev);
> + pm_runtime_dont_use_autosuspend(&dev->dev);
> + }
> }
Wouldn't it be better to remove power from the port after running the
code below?
> pcie_port_device_remove(dev);
> --
