On Tue, Feb 21, 2023 at 05:50:51PM +0800, Pin-yen Lin wrote:
> Register USB Type-C mode switches when the "mode-switch" property and
> relevant ports are available in Device Tree. Configure the crosspoint
> switch based on the entered alternate mode for a specific Type-C
> connector.
>
> Crosspoint switch can also be used for switching the output signal for
> different orientations of a single USB Type-C connector, but the
> orientation switch is not implemented yet. A TODO is added for this.
...
> +static void anx7625_typec_two_ports_update(struct anx7625_data *ctx)
> +{
> + int i;
unsigned?
+ Blank line.
> + /* Check if both ports available and do nothing to retain the current one */
> + if (ctx->port_data[0].dp_connected && ctx->port_data[1].dp_connected)
> + return;
> +
> + for (i = 0; i < 2; i++) {
> + if (ctx->port_data[i].dp_connected)
> + anx7625_set_crosspoint_switch(ctx,
> + ctx->port_data[i].orientation);
> + }
> +}
...
> + ctx->port_data[port->port_num].dp_connected =
> + state->alt && state->alt->svid == USB_TYPEC_DP_SID &&
I would move the first parameter of && to the separate line for slightly better
readability.
> + state->alt->mode == USB_TYPEC_DP_MODE;
...
> + for (i = 0; i < switch_desc->num_typec_switches; i++) {
> + struct drm_dp_typec_port_data *port = &switch_desc->typec_ports[i];
> + struct fwnode_handle *fwnode = port->fwnode;
> +
> + num_lanes = fwnode_property_count_u32(fwnode, "data-lanes");
> +
Redundant blank line.
> + if (num_lanes < 0) {
> + dev_err(dev,
> + "Error on getting data lanes count from %pfwP: %d\n",
> + fwnode, num_lanes);
> + ret = num_lanes;
Can be written differently:
> + goto unregister_mux;
> + }
ret = ...
if (ret < 0) {
...
}
num_lanes = ret;
What if it's 0?
> + ret = fwnode_property_read_u32_array(fwnode, "data-lanes",
> + dp_lanes, num_lanes);
> + if (ret) {
> + dev_err(dev,
> + "Failed to read the data-lanes variable: %d\n",
> + ret);
> + goto unregister_mux;
> + }
> +
> + ctx->port_data[i].orientation = (dp_lanes[0] / 2 == 0) ?
> + TYPEC_ORIENTATION_REVERSE : TYPEC_ORIENTATION_NORMAL;
> + ctx->port_data[i].dp_connected = false;
> + }
> + complete_all(&ctx->mux_register);
> +
> + return 0;
> +
> +unregister_mux:
> + complete_all(&ctx->mux_register);
> + anx7625_unregister_typec_switches(ctx);
> + return ret;
> +}
--
With Best Regards,
Andy Shevchenko
