From: Prashant Malani <pmalani@xxxxxxxxxxxx>
When searching the device graph for device matches, check the
remote-endpoint itself for a match.
Some drivers register devices for individual endpoints. This allows
the matcher code to evaluate those for a match too, instead
of only looking at the remote parent devices. This is required when a
device supports two mode switches in its endpoints, so we can't simply
register the mode switch with the parent node.
Signed-off-by: Prashant Malani <pmalani@xxxxxxxxxxxx>
Signed-off-by: Pin-yen Lin <treapking@xxxxxxxxxxxx>
---
(no changes since v6)
Changes in v6:
- New in v6
drivers/base/property.c | 15 +++++++++++++++
1 file changed, 15 insertions(+)
diff --git a/drivers/base/property.c b/drivers/base/property.c
index 2a5a37fcd998..48877af4e444 100644
--- a/drivers/base/property.c
+++ b/drivers/base/property.c
@@ -1223,6 +1223,21 @@ static unsigned int fwnode_graph_devcon_matches(struct fwnode_handle *fwnode,
break;
}
+ /*
+ * Some drivers may register devices for endpoints. Check
+ * the remote-endpoints for matches in addition to the remote
+ * port parent.
+ */
+ node = fwnode_graph_get_remote_endpoint(ep);
+ if (fwnode_device_is_available(node)) {
+ ret = match(node, con_id, data);
+ if (ret) {
+ if (matches)
+ matches[count] = ret;
+ count++;
+ }
+ }
+
node = fwnode_graph_get_remote_port_parent(ep);
if (!fwnode_device_is_available(node)) {
fwnode_handle_put(node);
--
2.39.0.314.g84b9a713c41-goog
