Re: [PATCH v2 2/7] PCI: ACPI: PM: Do not use pci_platform_pm_ops for ACPI

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi

Op 23-09-2021 om 15:51 schreef Ferry Toth:
Repost (with formatting removed, sorry for the noise)
Op 23-09-2021 om 13:30 schreef Rafael J. Wysocki:
On Wed, Sep 22, 2021 at 11:31 PM Ferry Toth<fntoth@xxxxxxxxx>  wrote:
Hi,
Op 20-09-2021 om 21:17 schreef Rafael J. Wysocki:
From: Rafael J. Wysocki<rafael.j.wysocki@xxxxxxxxx>

Using struct pci_platform_pm_ops for ACPI adds unnecessary
indirection to the interactions between the PCI core and ACPI PM,
which is also subject to retpolines.

Moreover, it is not particularly clear from the current code that,
as far as PCI PM is concerned, "platform" really means just ACPI
except for the special casess when Intel MID PCI PM is used or when
ACPI support is disabled (through the kernel config or command line,
or because there are no usable ACPI tables on the system).

To address the above, rework the PCI PM code to invoke ACPI PM
functions directly as needed and drop the acpi_pci_platform_pm
object that is not necessary any more.

Accordingly, update some of the ACPI PM functions in question to do
extra checks in case the ACPI support is disabled (which previously
was taken care of by avoiding to set the pci_platform_ops pointer
in those cases).

Signed-off-by: Rafael J. Wysocki<rafael.j.wysocki@xxxxxxxxx>
---

v1 -> v2:
      * Rebase on top of the new [1/7] and move dropping struct
        pci_platform_pm_ops to a separate patch.
I wanted to test this series on 5.15-rc2 but this patch 2/7 doesn't
apply (after 1/7 applied). Should I apply this on another tree?
This is on top of
https://patchwork.kernel.org/project/linux-acpi/patch/2793105.e9J7NaK4W3@kreacher/
which is not yet in any tree.

Sorry for the confusion.
No problem at all. If I can I will try to report back tonight. Else, will be delayed 2 due to a short break.

With those 3 extra patches followed by 7 from this series it builds. But on boot I get:
dwc3 dwc3.0.auto: this is not a DesignWare USB3 DRD Core
Then after this it reboots. Nothing in the logs. Nothing else on console, I guess something goes wrong early.

I tried both in host / device mode - no change.

Normally in host mode I have:
usb usb1: New USB device found, idVendor=1d6b, idProduct=0002, bcdDevice= 5.14
Only ref to dwc3 is:
tusb1210 dwc3.0.auto.ulpi: using ACPI for GPIO lookup / using lookup tables for GPIO lookup / No GPIO consumer cs found



[Index of Archives]     [Linux IBM ACPI]     [Linux Power Management]     [Linux Kernel]     [Linux Laptop]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux