Hi,
There's a tiny bug in 2.6.18-rc1.
In drivers/acpi/bus.c::acpi_bus_set_power() there's a check to see if
the device is power_manageable and if not then print a debug message
and return -ENODEV. The debug printk() is missing a \n.
The printk statement looks like this :
printk(KERN_DEBUG "Device `[%s]' is not power manageable",
device->kobj.name);
As you can see, there's no newline at the end, and that causes
problems for the next message to be printed.
On my system the above results in this in dmesg :
...
Device `[PEB1]' is not power manageable<6>ACPI: PCI Interrupt 0000:00:01.0[A] -> GSI 29 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:00:01.0 to 64
Device `[PEB2]' is not power manageable<6>ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 34 (level, low) -> IRQ 17
...
Adding a newline (as the patch below does) turns this into
...
Device `[PEB1]' is not power manageable
ACPI: PCI Interrupt 0000:00:01.0[A] -> GSI 29 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:00:01.0 to 64
Device `[PEB2]' is not power manageable
ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 34 (level, low) -> IRQ 17
...
Which is much nicer :-)
Signed-off-by: Jesper Juhl <jesper.juhl@xxxxxxxxx>
---
drivers/acpi/bus.c | 2 +-
1 files changed, 1 insertion(+), 1 deletion(-)
--- linux-2.6.18-rc1-orig/drivers/acpi/bus.c 2006-07-06 19:39:29.000000000 +0200
+++ linux-2.6.18-rc1/drivers/acpi/bus.c 2006-07-06 23:23:12.000000000 +0200
@@ -192,7 +192,7 @@ int acpi_bus_set_power(acpi_handle handl
/* Make sure this is a valid target state */
if (!device->flags.power_manageable) {
- printk(KERN_DEBUG "Device `[%s]' is not power manageable",
+ printk(KERN_DEBUG "Device `[%s]' is not power manageable\n",
device->kobj.name);
return -ENODEV;
}
-
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
