Shahin,
scanModem reports that your modem is supported by HSF|HCF modem
drivers. Try the hsfmodem driver first:
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset detected on
NAME="Audio device: Intel Corporation 82801G "
package="both hcfpcimodem and hsfmodem"
CLASS=0403
PCIDEV=8086:27d8
SUBSYS=1019:2639
IRQ=16
IDENT=HCF.HSF
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801G
Primary device ID: 8086:27d8
Support type needed or chipset: HCF.HSF
Writing DOCs/Intel.txt
For owners of a Dell PCs with Conexant HSF modems, a driver source
package with full speed enabled is available, but requires driver
compiling. Read DOCs/Conexant.txt
8086:27d8 could be either a HSF or HCF Conexant modem, because of ambiguous
use of the PCI ID by modem assemblers. First try the hcfpcimodem package.
If the installation aborts, then use the hsfmodem package. Read
DOCs/Conexant.txt
for details and Modem/DOCs/YourSystem.txt for follow through guidance.
Modem support packages from Linuxant include resources for compiling drivers.
If an installer package matching your kernel_version is not provided,
just install a generic code package.
From http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php
download hsfmodem-7.80.02.05full_k2.6.27_7_generic_ubuntu_i386.deb.zip
Under Linux unpack with:
$ unzip hsfmodem*.zip
Then install with:
$ sudo dpkg -i hsfmodem*.deb
Subsequently, the modem should be found with
$ sudo wvdialconf /etc/wvdial.conf
Edit in your personal information with:
$ sudo gedit /etc/wvdial.conf
and try dialing out with:
$ sudo wvdial.
See DOCs/Testing.txt for details.
The directions following below need only be pursued, if the above
procedures are not adequate.
Start at http://www.linuxant.com/drivers/hsf/downloads-license.php to find the
hsfmodem package matching your System. For several Linux distros, there are
precompiled drivers matched to specific kernels. These have within the FileName,
your KernelVersion: 2.6.27_7_generic
They can be found through
http://www.linuxant.com/drivers/hsf/full/downloads.php
A more precise location may be given a few paragraphs below.
If an EXACT Match with your your KernelVersion is not found, one of the
"Generic packages with source" near the bottom of the page must be used.
Downloaded packages must be moved into the Linux partition (home folder is OK)
and unzipped with:
unzip hsf*.zip
The installation command for a .deb suffic packages is, with root/adm
permission:
sudo dpkg -i hsf*.deb
while for .rpm suffix it is, with:
rpm -i hsf*.rpm
Read DOCs/Conexant.txt
Regards,
Antonio
On Wed, Apr 27, 2011 at 11:11 AM, shahin safe <shahin6@xxxxxxxxx> wrote:
>
>
