Claudio,
scanModem reports that your modem is supported via SLMODEMD.gcc4.4.tar.gz :
For candidate modem in: 00:1f.6
0703 Modem: Intel Corporation 82801DB/DBL/DBM
Primary device ID: 8086:24c6
Subsystem PCI_id 1631:d005
Softmodem codec or chipset from diagnostics: SIL22, a Smartlink type
from Archives:
This is a NEW softmodem case! Please send the output ModemData.txt
to DISCUSS@xxxxxxxxxxxxx to enrich the Archive and help others!
If further assistance is not needed, please use email Subject:
New Case Only
-------------------------------------------
Support type needed or chipset: slmodemd
An ALSA (Advanced Linux Sound Architecture) modem driver: snd-intel8x0m
provides Low Level support enabling contact with the modem hardware.
For all BUT Conexant chip soft modems (using hsfmodem software)
complementary High Level support is through a Smartlink utility: slmodemd
Download from http://linmodems.technion.ac.il/packages/smartlink/
the package SLMODEMD.gcc4.4.tar.gz having a compiled slmodemd. Unpack
under Linux with:
$ tar zxf SLMODEMD.gcc4.4.tar.gz
and read instructions therein. But briefly, the modem is setup with command:
sudo slmodemd -c YOUR_COUNTRY --alsa modem:1
reporting dynamic creation of ports:
/dev/ttySL0 --> /dev/pts/N , with N some number
Read DOCs/Smartlink.txt and Modem/DOCs/YourSystem.txt for follow
through guidance.
If you have downloaded the package SLMODEMD.gcc4.4.tar.gz and tried
the above instructions and are not getting anywhere/(modem does not
respond) it could be because of
For candidate card in slot 00:1f.6, firmware information and bootup
diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:1f.6 8086:24c6 1631:d005 Modem: Intel Corporation 82801DB/DBL/DBM
Modem interrupt assignment and sharing:
5: 137 XT-PIC-XT yenta, Intel 82801DB-ICH4, Intel
82801DB-ICH4 Modem
--- Bootup diagnostics for card in PCI slot 00:1f.6 ----
[ 0.071472] pci 0000:00:1f.6: reg 10 io port: [0xe300-0xe3ff]
[ 0.071480] pci 0000:00:1f.6: reg 14 io port: [0xe400-0xe47f]
[ 0.071521] pci 0000:00:1f.6: PME# supported from D0 D3hot D3cold
[ 0.071525] pci 0000:00:1f.6: PME# disabled
[ 0.956536] serial 0000:00:1f.6: PCI INT B -> Link[LNKB] -> GSI 5
(level, low) -> IRQ 5
[ 0.956547] serial 0000:00:1f.6: PCI INT B disabled
[ 3186.856643] Intel ICH Modem 0000:00:1f.6: PCI INT B -> Link[LNKB]
-> GSI 5 (level, low) -> IRQ 5
[ 3186.856669] Intel ICH Modem 0000:00:1f.6: setting latency timer to 64
The PCI slot 00:1f.6 of the modem card may be disabled early in
a bootup process, but then enabled later. If modem drivers load
but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx
if help is needed.
Let us know if the package SLMODEMD.gcc4.4.tar.gz works or not, and if
the driver loads fine but does not respond, follow the above
instructions to see if it can work or not.
Regards,
Antonio
On 12/1/09, Claudio Mantegazza <ermante@xxxxxxxxxxx> wrote:
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> Excuse me if i send you directly my request but the linmiodemds.ord mail
> server doesn't accept my email...
>
> i'm not able to configure my internal modem...
>
> can you help me, please ?
>
> Thanks
> Claudio
>
> ----------------------------------------------------------------------------
>
>
>
>> Date: Fri, 27 Nov 2009 14:54:13 +0000
>> From: MAILER-DAEMON@xxxxxxxxxxxxxx
>> To: ermante@xxxxxxxxxxx
>> Subject: failure notice
>>
>> Hi. This is the qmail-send program at ns0.crynwr.com.
>> I'm afraid I wasn't able to deliver your message to the following
>> addresses.
>> This is a permanent error; I've given up. Sorry it didn't work out.
>>
>> <discuss@xxxxxxxxxxxxx>:
>> ezmlm-reject: fatal: Sorry, I don't accept messages of MIME Content-Type
>> 'multipart/alternative' (#5.2.3)
>>
>> --- Below this line is a copy of the message.
>>
>> Return-Path: <ermante@xxxxxxxxxxx>
>> Received: (qmail 15866 invoked from network); 27 Nov 2009 14:54:13 -0000
>> Received: from blu0-omc4-s1.blu0.hotmail.com (65.55.111.140)
>> by pdam.crynwr.com with SMTP; 27 Nov 2009 14:54:13 -0000
>> Received: from BLU111-W19 ([65.55.111.137]) by
>> blu0-omc4-s1.blu0.hotmail.com with Microsoft SMTPSVC(6.0.3790.3959);
>> Fri, 27 Nov 2009 06:54:13 -0800
>> Message-ID: <BLU111-W1989187438912763318DC2AB9A0@xxxxxxx>
>> Return-Path: ermante@xxxxxxxxxxx
>> Content-Type: multipart/alternative;
>> boundary="_5f2b0def-3b71-4628-bbec-d4805da16471_"
>> X-Originating-IP: [213.140.27.251]
>> From: Claudio Mantegazza <ermante@xxxxxxxxxxx>
>> To: <discuss@xxxxxxxxxxxxx>
>> Subject: Claudio, Italy kernel 2.6.31-15-generic
>> Date: Fri, 27 Nov 2009 15:54:13 +0100
>> Importance: Normal
>> MIME-Version: 1.0
>> X-OriginalArrivalTime: 27 Nov 2009 14:54:13.0790 (UTC)
>> FILETIME=[7C1F63E0:01CA6F71]
>>
>> --_5f2b0def-3b71-4628-bbec-d4805da16471_
>> Content-Type: text/plain; charset="iso-8859-1"
>> Content-Transfer-Encoding: quoted-printable
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> i'm not able to configure my internal modem...
>>
>> Can u help me=2C please?
>>
>> Thanks... =20
>> _________________________________________________________________
>> Messenger su ogni PC=2C prova la Web Bar!
>> http://www.messenger.it/=
>>
>> --_5f2b0def-3b71-4628-bbec-d4805da16471_
>> Content-Type: text/html; charset="iso-8859-1"
>> Content-Transfer-Encoding: quoted-printable
>>
>> <html>
>> <head>
>> <style><!--
>> .hmmessage P
>> {
>> margin:0px=3B
>> padding:0px
>> }
>> body.hmmessage
>> {
>> font-size: 10pt=3B
>> font-family:Verdana
>> }
>> --></style>
>> </head>
>> <body class=3D'hmmessage'>
>> <br><br>
>>
>>
>>
>> <style>
>> .ExternalClass .ecxhmmessage P
>> {padding:0px=3B}
>> .ExternalClass body.ecxhmmessage
>> {font-size:10pt=3Bfont-family:Verdana=3B}
>> </style>
>>
>>
>> i'm not able to configure my internal modem...<br><br>Can u help me=2C
>> plea=
>> se?<br><br>Thanks... =3B =3B <br /><hr />Crea e
>> condivid=
>> i i tuoi filmati con <a
>> href=3D'http://www.windowslive.it/moviemaker.aspx'=
>> target=3D'_new'>Movie Maker</a></body>
>> </html>=
>>
>> --_5f2b0def-3b71-4628-bbec-d4805da16471_--
>
> _________________________________________________________________
> I tuoi amici sempre a portata di clic, sul nuovo Web Messenger
> http://www.windowslive.it/foto.aspx
