Abrham,
scanModem reports that you have an 11c11040 modem by LSI. It is
supported, but you may have to downgrade your kernel to an earlier
one.
\begin{QUOTE}
Currently, the dkms-agrsm code is NOT competent for 2.6.28 and later kernels.
A short term fix is to install linux-image + linux-headers packages
for earlier kernels.
For detailed instructions for Ubuntu Jaunty with 2.6.28 kernels, see
http://linmodems.technion.ac.il/bigarch/archive-nineth/msg01316.html
\end{QUOTE}
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset detected on
NAME="Audio device: Intel Corporation 82801I "
CLASS=0403
PCIDEV=8086:293e
SUBSYS=1179:ff66
IRQ=22
HDA=8086:293e
SOFT=8086:293e.HDA
HDAchipVendorID=11c1
CHIP=0x11c11040
IDENT=agrsm
Driver=agrsm
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801I
Primary device ID: 8086:293e
Subsystem PCI_id 1179:ff66
Softmodem codec or chipset from diagnostics: 0x11c11040
from Archives:
The HDA card softmodem chip is 0x11c11040
Support type needed or chipset: agrsm
Writing DOCs/Intel.txt
The AgereSystems/LSI agrsm code supports compiling of a agrmodem +
agrsm driver pair.
One resource site is http://linmodems.technion.ac.il/packages/ltmodem/11c11040/
Thereat get the agrsm_howto.txt and one of the agrsm-tools packages.
The initial agrsm_howto.txt compiling steps are only cogent to modems
with PCI IDs:
11c1:0620, 11c1:048c and 11c1:048f chips.
They use the agrsm-20090418.tar.gz package.
The agrsm-tools sets a useful symbolic link and a agrsm-test utlity
For AgereSystems/LSI with Vendor 11c1 chips hosted on High Definition
Audio cards, there may be support
through the agrsm resources (providing an agrmodem + agrserial driver
pair) as an alternative to usage
of the snd-hda-intel driver + slmodemd helper. For the 11c11040 modem
chip, ONLY the agrsm code is competent.
Your Linux distro's dkms package should be first installed, as it
directs the installation of modem
specific dkms-agrsm resources, and also directs auto-installation of
new drivers upon kernel upgrades.
Currently, the dkms-agrsm code is NOT competent for 2.6.28 and later kernels.
A short term fix is to install linux-image + linux-headers packages
for earlier kernels.
For detailed instructions for Ubuntu Jaunty with 2.6.28 kernels, see
http://linmodems.technion.ac.il/bigarch/archive-nineth/msg01316.html
The primary dkms-agrsm resource site is
http://linux.zsolttech.com/linmodem/agrsm/
whereat a few different packaging types are available. Debian type
installers (supporting Ubuntu too)
are copied to http://linmodems.technion.ac.il/packages/ltmodem/11c11040/
. Thereat the current package
is the dkms-agrsm_2.1.80-6_i386.deb is for Agere/LSI chipsets hosted
on High Definition Audio cards.
Read the Modem/DOCs/Agrsm.txt for details.
scanModem also reports that you don't have wvdial installed on your system:
The dialer utility package WVDIAL does not appear to be installed on
your System.
For Ubuntu Jaunty users, there are at the bottom of
http://linmodems.technion.ac.il/packages/:
wvdial_jaunty_amd64.zip for x86_64, 64 bit bus systems.
wvdial_jaunty_i386.zip for 32 bit systems.
These are about 1 MB in size. After downloaded and copied into your
Linux partition:
$ unzip wv*.zip
Within the new folder:
$ sudo dpkg -i *.deb
will complete the wvdial installation
Please read Modem/DOCs/wvdial.txt for usage information.
and also if and if you install the drivers correctly and everything
almost works but does not, it might be because of :
For candidate card in slot 00:1b.0, firmware information and bootup
diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:1b.0 8086:293e 1179:ff66 Audio device: Intel Corporation 82801I
Modem interrupt assignment and sharing:
22: 1415 1469 IO-APIC-fasteoi HDA Intel
--- Bootup diagnostics for card in PCI slot 00:1b.0 ----
[ 1.097177] pci 0000:00:1b.0: reg 10 64bit mmio: [0xd6700000-0xd6703fff]
[ 1.097218] pci 0000:00:1b.0: PME# supported from D0 D3hot D3cold
[ 1.097223] pci 0000:00:1b.0: PME# disabled
[ 28.784859] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level,
low) -> IRQ 22
[ 28.784927] HDA Intel 0000:00:1b.0: setting latency timer to 64
The PCI slot 00:1b.0 of the modem card may be disabled early in
a bootup process, but then enabled later. If modem drivers load
but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx
if help is needed.
Regards,
Antonio
On 10/13/09, Abrham Tamrat Desta <abrhamtamrat@xxxxxxxxx> wrote:
> Dear sir/madam,
>
> I can't wait to surf the internet using ubuntu so, please tell me what to
> do.
>
> Best regards,
> Abrham Tamrat
>
