Danial
Modem: Intel Corporation 82801DB/DBL/DBM
Primary device ID: 8086:24c6
Subsystem PCI_id 1014:0524
Softmodem codec or chipset from diagnostics:
from Archives: SIL27
is in principle supported by a driver snd-intel8x0m which is in on your System
It should usually autoload, but can be manually loaded if necessary by
$ sudo modprobe snd-intel8x0m
You can verify loading with
$ lsmod | grep intel8x0m
which should display this driver and others on which it is dependent.
At http://linmodems.technion.ac.il/packages/smartlink/ there is a complementing
SLMODEMD_gcc4.2_alsa1.0.17.tar.gz which provides a complementing
slmodemd utility. Unpack this package under Linux with:
$ tar zxf SLMODEMD*.tar.gz
Browse the files in the new folder, and then therein run:
$ sudo ./setup
But your Major first problem is the report:
---------------
[ 1.873663] serial 0000:00:1f.6: PCI INT B disabled
The PCI slot 00:1f.6 of the modem card may be disabled early in
a bootup process, but then enabled later. If modem drivers load
but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx
if help is needed.
----------------
This problem may be cured by detaching all external device, both PCMCIA and USB,
These are all sharing the same interrupt
11: 266170 XT-PIC-XT ehci_hcd:usb1, uhci_hcd:usb2,
uhci_hcd:usb3, uhci_hcd:usb4, yenta, yenta, eth1, Intel 82801DB-ICH4,
radeon@pci:0000:01:00.0, eth0
Do this before a reboot and also before testing the modem also do:
$ sudo ifconfig eth0 down
$ sudo ifconfig eth1 down
Then remove and reload the driver
$ sudo modprobe -r snd-intel8x0m
$ sudo modprobe snd-intel8x0m
The first modem functional test is:
$ sudo slmodemd -c IRAN --alsa modem:1
Report back presently.
MarvS
scanModem maintainer
On Sun, Feb 1, 2009 at 7:16 AM, دانیال بهزادی <dani.behzi@xxxxxxxxx> wrote:
> Only plain text email is forwarded by the Discuss@xxxxxxxxxxxxx List Server,
> as HTML can contain viruses. Use as the email Subject Line:
> YourName, YourCountry kernel 2.6.27-7-generic
> With this Subject Line cogent experts will be alerted, and useful
> case names left in the Archive.
> YourCountry will enable Country specific guidance. Linux experts in
> YourCountry
> can be found through: http://www.linux.org/groups/index.html.
> They will know your Country's modem code, which may be essential for
> dialup service.
> Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an
> Internet Provider mail filters.
> So in a day, also check the Archived responses at http://www.linmodems.org
> -------------------------- System information ----------------------------
> CPU=i686,
> Linux version 2.6.27-7-generic (buildd@rothera) (gcc version 4.3.2
> (Ubuntu 4.3.2-1ubuntu10) ) #1 SMP Fri Oct 24 06:42:44 UTC 2008
> scanModem update of: 2008_08_26
>
> There are no blacklisted modem drivers in /etc/modprobe* files
> Attached USB devices are:
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 22b8:608d Motorola PCS
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 1d6b:0002 Linux Foundation 2.0 root hub
>
> USB modems not recognized
>
> For candidate card in slot 00:1f.6, firmware information and bootup
> diagnostics are:
> PCI slot PCI ID SubsystemID Name
> ---------- --------- --------- --------------
> 00:1f.6 8086:24c6 1014:0524 Modem: Intel Corporation 82801DB/DBL/DBM
>
> Modem interrupt assignment and sharing:
> 11: 266170 XT-PIC-XT ehci_hcd:usb1, uhci_hcd:usb2,
> uhci_hcd:usb3, uhci_hcd:usb4, yenta, yenta, eth1, Intel 82801DB-ICH4,
> radeon@pci:0000:01:00.0, eth0
> --- Bootup diagnostics for card in PCI slot 00:1f.6 ----
> [ 0.522111] PCI: 0000:00:1f.6 reg 10 io port: [2400, 24ff]
> [ 0.522117] PCI: 0000:00:1f.6 reg 14 io port: [2000, 207f]
> [ 0.522152] pci 0000:00:1f.6: PME# supported from D0 D3hot D3cold
> [ 0.522157] pci 0000:00:1f.6: PME# disabled
> [ 1.873654] serial 0000:00:1f.6: PCI INT B -> Link[LNKB] -> GSI 11
> (level, low) -> IRQ 11
> [ 1.873663] serial 0000:00:1f.6: PCI INT B disabled
>
> The PCI slot 00:1f.6 of the modem card may be disabled early in
> a bootup process, but then enabled later. If modem drivers load
> but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
> Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx
> if help is needed.
>
>
>
> ===== Advanced Linux Sound Architecture (ALSA) diagnostics =====
> The ALSA packages provide audio support and also drivers for some modems.
> ALSA diagnostics are written during bootup to /proc/asound/ folders.
>
> The ALSA verion is 1.0.17
> The modem cards detected by "aplay -l" are: None
>
>
> The /proc/asound/pcm file reports:
> -----------------------
> 00-04: Intel ICH - IEC958 : Intel 82801DB-ICH4 - IEC958 : playback 1
> 00-03: Intel ICH - ADC2 : Intel 82801DB-ICH4 - ADC2 : capture 1
> 00-02: Intel ICH - MIC2 ADC : Intel 82801DB-ICH4 - MIC2 ADC : capture 1
> 00-01: Intel ICH - MIC ADC : Intel 82801DB-ICH4 - MIC ADC : capture 1
> 00-00: Intel ICH : Intel 82801DB-ICH4 : playback 1 : capture 1
>
> about /proc/asound/cards:
> ------------------------
> 0 [I82801DBICH4 ]: ICH4 - Intel 82801DB-ICH4
> Intel 82801DB-ICH4 with AD1981B at irq 11
> === Finished firmware and bootup diagnostics, next deducing cogent software. ===
>
> Predictive diagnostics for card in bus 00:1f.6:
> Modem chipset detected on
> NAME="Modem: Intel Corporation 82801DB/DBL/DBM "
> CLASS=0703
> PCIDEV=8086:24c6
> SUBSYS=1014:0524
> IRQ=11
> SOFT=8086:24c6.MC97
> CodecArchived=SIL27
> IDENT=slmodemd
> SLMODEMD_DEVICE=modem:1
> Driver=snd-intel8x0m
>
> For candidate modem in: 00:1f.6
> 0703 Modem: Intel Corporation 82801DB/DBL/DBM
> Primary device ID: 8086:24c6
> Subsystem PCI_id 1014:0524
> Softmodem codec or chipset from diagnostics:
> from Archives: SIL27
>
>
>
> Support type needed or chipset: slmodemd
>
> An ALSA (Advanced Linux Sound Architecture) modem driver: snd-intel8x0m
> provides Low Level support enabling contact with the modem hardware.
> For all BUT Conexant chip soft modems (using hsfmodem software)
> complementary High Level support is through a Smartlink utility: slmodemd
>
> Download from http://linmodems.technion.ac.il/packages/smartlink/
> the package SLMODEMD.gcc4.3.tar.gz having a compiled slmodemd. Unpack
> under Linux with:
> $ tar zxf SLMODEMD.gcc4.3.tar.gz
> and read instructions therein. But briefly, the modem is setup with command:
> sudo slmodemd -c YOUR_COUNTRY --alsa modem:1
> reporting dynamic creation of ports:
> /dev/ttySL0 --> /dev/pts/N , with N some number
> Read DOCs/Smartlink.txt and Modem/DOCs/YourSystem.txt for follow
> through guidance.
>
> ----------------end Softmodem section --------------
>
> Writing DOCs/Intel.txt
> Writing DOCs/Smartlink.txt
> ============ end Smartlink section =====================
>
> Completed candidate modem analyses.
>
> The base of the UDEV device file system is: /dev/.udev
>
> Versions adequately match for the compiler installed: 4.3.2
> and the compiler used in kernel assembly: 4.3.2
>
>
>
> Minimal compiling resources appear complete:
> make utility - /usr/bin/make
> Compiler version 4.3
> linuc_headers base folder /lib/modules/2.6.27-7-generic/build
>
> However some compilations and executable functions may need additional files,
> in the FileNames.h (so called kernel "h"eaders) collection installed
> in /usr/include/ .
> For martian_modem, additional required packages are needed. The also
> required headers of package libc6 are commonly installed by default.
> Compiling hsfmodem drivers does require linux-libc-dev and libc6-dev
> packages, for kernels 2.6.24 and later versions.
> In not included on your install CD, search for them at
> http://packages.ubuntu.com
> or comparable Repository for other Linux distros.
> When compiling ALSA drivers, the utility "patch" will also be needed.
>
>
>
>
> If a driver compilation fails, with message including some lack of
> some FileName.h (stdio.h for example), then
> Some additional kernel-header files need installation to /usr/include.
> The minimal additional packages are libc6-dev
> and any of its dependents, under Ubuntu linux-libc-dev
>
> If an alternate ethernet connection is available,
> $ apt-get update
> $ apt-get -s install linux-kernel-devel
> will install needed packages.
> For Debian/Ubuntu related distributions, run the following command to
> display the needed package list:
>
> Otherwise packages have to be found through http://packages.ubuntu.com
> Once downloaded and transferred into a Linux partition,
> they can be installed alltogether with:
> $ sudo dpkg -i *.deb
>
>
> Checking pppd properties:
> -rwsr-xr-- 1 root dip 273064 2008-10-16 05:21 /usr/sbin/pppd
>
> In case of an "error 17" "serial loopback" problem, see:
> http://linmodems.technion.ac.il/linmodems/archive-sixth/msg02637.html
>
> To enable dialout without Root permission do:
> $ su - root (not for Ubuntu)
> sudo chmod a+x /usr/sbin/pppd
> or under Ubuntu related Linuxes
> sudo chmod a+x /usr/sbin/pppd
>
> Checking settings of: /etc/ppp/options
> asyncmap 0
> noauth
> crtscts
> lock
> hide-password
> modem
> proxyarp
> lcp-echo-interval 30
> lcp-echo-failure 4
> noipx
>
> In case of a message like:
> Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
> see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
>
> Read Modem/DOCs/YourSystem.txt concerning other COMM channels: eth0 eth1
> Which can interfere with Browser naviagation.
>
> Don't worry about the following, it is for experts should trouble
> shooting be necessary.
> ==========================================================
>
> Checking for modem support lines:
> --------------------------------------
> /device/modem symbolic link:
> slmodemd created symbolic link /dev/ttySL0:
> Within /etc/udev/ files:
>
> Within /etc/modprobe.conf files:
> /etc/modprobe.d/blacklist-modem:# Uncomment these entries in order to
> blacklist unwanted modem drivers
> /etc/modprobe.d/blacklist-modem:# blacklist snd-atiixp-modem
> /etc/modprobe.d/blacklist-modem:# blacklist snd-via82xx-modem
> /etc/modprobe.d/alsa-base:options snd-atiixp-modem index=-2
> /etc/modprobe.d/alsa-base:options snd-via82xx-modem index=-2
> Within any ancient /etc/devfs files:
>
> Within ancient kernel 2.4.n /etc/module.conf files:
>
> --------- end modem support lines --------
>
