Only plain text email is forwarded by the Discuss@xxxxxxxxxxxxx List Server,
as HTML can contain viruses. Use as the email Subject Line:
YourName, YourCountry kernel 2.6.27.5-117.fc10.i686
With this Subject Line cogent experts will be alerted, and useful
case names left in the Archive.
YourCountry will enable Country specific guidance. Linux experts in
YourCountry
can be found through: http://www.linux.org/groups/index.html.
They will know your Country's modem code, which may be essential for
dialup service.
Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an
Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org
-------------------------- System information ----------------------------
CPU=i686,
Linux version 2.6.27.5-117.fc10.i686
(mockbuild@xxxxxxxxxxxxxxxxxxxxxxxxxxx) (gcc version 4.3.2 20081105
(Red Hat 4.3.2-7) (GCC) ) #1 SMP Tue Nov 18 12:19:59 EST 2008
scanModem update of: 2008_08_26
There are no blacklisted modem drivers in /etc/modprobe* files
Attached USB devices are:
ID 1d6b:0002 Linux Foundation 2.0 root hub
ID 04f3:0210 Elan Microelectronics Corp. AM-400 Hama Optical Mouse
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0002 Linux Foundation 2.0 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
USB modems not recognized
For candidate card in slot 00:1b.0, firmware information and bootup
diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:1b.0 8086:284b 1025:0133 Audio device: Intel Corporation 82801H
Modem interrupt assignment and sharing:
22: 444 IO-APIC-fasteoi HDA Intel
--- Bootup diagnostics for card in PCI slot 00:1b.0 ----
PCI: 0000:00:1b.0 reg 10 64bit mmio: [fc200000, fc203fff]
pci 0000:00:1b.0: PME# supported from D0 D3hot D3cold
pci 0000:00:1b.0: PME# disabled
HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22
HDA Intel 0000:00:1b.0: setting latency timer to 64
The PCI slot 00:1b.0 of the modem card may be disabled early in
a bootup process, but then enabled later. If modem drivers load
but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx
if help is needed.
===== Advanced Linux Sound Architecture (ALSA) diagnostics =====
The ALSA packages provide audio support and also drivers for some modems.
ALSA diagnostics are written during bootup to /proc/asound/ folders.
The ALSA verion is 1.0.17
The modem cards detected by "aplay -l" are: None
The /proc/asound/pcm file reports:
-----------------------
00-04: ALC268 Analog : ALC268 Analog : capture 1
00-00: ALC268 Analog : ALC268 Analog : playback 1 : capture 1
about /proc/asound/cards:
------------------------
0 [Intel ]: HDA-Intel - HDA Intel
HDA Intel at 0xfc200000 irq 22
PCI slot 00:1b.0 has a High Definition Audio Card
The drivers are in the kernel modules tree at:
/lib/modules/2.6.27.5-117.fc10.i686/kernel/sound/pci/hda/snd-hda-intel.ko
The modem codec file for the HDA card is: /proc/asound/card0/codec#1
--------------------------------------------------------
Codec: Conexant ID 2c06
Address: 1
Vendor Id: 0x14f12c06
Subsystem Id: 0x10250093
Revision Id: 0x100000
Modem Function Group: 0x2
The audio card hosts a softmodem chip: 0x14f12c06
14f1 is the Conexant Vendor ID, and 0x14f12c06 a softmodem chipset.
Get a hsfmodem package through http://www.linuxant.com
If not a Conexant modem, the driver hsfmodem-drivers with its dependent drivers:
----------
provide audio + modem support with the modem chip residing on the subsystem.
Any particular card can host any one of several soft modem chips.
=== Finished firmware and bootup diagnostics, next deducing cogent software. ===
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset detected on
NAME="Audio device: Intel Corporation 82801H "
CLASS=0403
PCIDEV=8086:284b
SUBSYS=1025:0133
IRQ=22
HDA=8086:284b
SOFT=8086:284b.HDA
CHIP=0x14f12c06
CodecClass=14f1
IDENT=hsfmodem
Driver=hsfmodem-drivers
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801H
Primary device ID: 8086:284b
Subsystem PCI_id 1025:0133
Softmodem codec or chipset from diagnostics: 0x14f12c06
from Archives:
The HDA card softmodem chip is 0x14f12c06
Support type needed or chipset: hsfmodem
Writing DOCs/Intel.txt
For owners of a Dell PCs with Conexant HSF modems, a driver source
package with full speed enabled is available, but requires driver
compiling. Read DOCs/Conexant.txt
Start at http://www.linuxant.com/drivers/hsf/downloads-license.php to find the
hsfmodem package matching your System. For several Linux distros, there are
precompiled drivers matched to specific kernels. These have within the FileName,
your KernelVersion: 2.6.27.5_117.fc10.i686
They can be found through
http://www.linuxant.com/drivers/hsf/full/downloads.php
A more precise location may be given a few paragraphs below.
If an EXACT Match with your your KernelVersion is not found, one of the
"Generic packages with source" near the bottom of the page must be used.
Downloaded packages must be moved into the Linux partition (home folder is OK)
and unzipped with:
unzip hsf*.zip
The installation command for a .deb suffic packages is, with root/adm
permission:
dpkg -i hsf*.deb
while for .rpm suffix it is, with:
rpm -i hsf*.rpm
Support for Conexant chips hosted on High Definition Audio cards may require
installation of additional packages, one of the alsa-driver-linuxant packages
on http://www.linuxant.com/alsa-driver/ At the same time download the
alsa-driver-1.0.17-1.patch , in case it prove to be later needed. During the
hsfmodem install, there will be a message if there is necessary installation of
alsa-driver-linuxant
The installation command for a .deb suffic packages is, with root/adm
permission:
alsa* -i hsf*.deb
while for .rpm suffix it is, with:
rpm -i hsf*.rpm
There may a message that "Dependencies" are not satisfied. In this
case the Ubuntu/Debian packages to be installed are linux-libc-dev &
libc6-dev. Package
names may be different for other Linuxes. If not on your install CD, these
packages can be searched for at http://packages.ubuntu.com. After download,
they can be coinstalled with:
dpkg -i li*.deb
Again try the alsa-driver-linuxant
There may be a message that the patch must be applied. In this case get the
ftp://ftp.alsa-project.org/pub/driver/alsa-driver-1.0.17.tar.bz2
Under Linux, this package is unpacked with:
$ tar jxf alsa*.tar.bz2
Next the patch is applied with:
$ patch -p0 < alsa-driver-1.0.17-1.patch
See http://linmodems.technion.ac.il/bigarch/archive-eighth/msg00838.html
for details on compiling and installing replacement snd-hda-intel + its
dependent drivers.
After the installation is completed, rerun the hsfmodem installation.
Reboot and try to detect the modem with Root permission:
wvdialconf /etc/wvdial.conf
Start at http://www.linuxant.com/drivers/hsf/full for
eventually download of a hsfmodem-7.68.00.12full_k.???.zip package
with ??? the package type (deb, rpm, tar etc)
These packages have compiled drivers but will also compile a driver,
if there is a mismatch between the resident kernel and provided driver.
The generic hsfmodem-7.68.00.12full.tar.gz package only provides
compiling support
Read DOCs/Conexant.txt
Writing DOCs/Conexant.txt
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.3.2
and the compiler used in kernel assembly: 4.3.2
Minimal compiling resources appear complete:
make utility - /usr/bin/make
Compiler version 4.3
linuc_headers base folder /lib/modules/2.6.27.5-117.fc10.i686/build
However some compilations and executable functions may need additional files,
in the FileNames.h (so called kernel "h"eaders) collection installed
in /usr/include/ .
For martian_modem, additional required packages are needed. The also
required headers of package libc6 are commonly installed by default.
Compiling hsfmodem drivers does require linux-libc-dev and libc6-dev
packages, for kernels 2.6.24 and later versions.
In not included on your install CD, search for them at
http://packages.ubuntu.com
or comparable Repository for other Linux distros.
When compiling ALSA drivers, the utility "patch" will also be needed.
If a driver compilation fails, with message including some lack of
some FileName.h (stdio.h for example), then
Some additional kernel-header files need installation to /usr/include.
The minimal additional packages are libc6-dev
and any of its dependents, under Ubuntu linux-libc-dev
If an alternate ethernet connection is available,
$ apt-get update
$ apt-get -s install linux-kernel-devel
will install needed packages.
For Debian/Ubuntu related distributions, run the following command to
display the needed package list:
Otherwise packages have to be found through http://packages.ubuntu.com
Once downloaded and transferred into a Linux partition,
they can be installed alltogether with:
$ sudo dpkg -i *.deb
Checking pppd properties:
-r-xr-xr-x 1 root root 318632 2008-08-29 00:48 /usr/sbin/pppd
In case of an "error 17" "serial loopback" problem, see:
http://linmodems.technion.ac.il/linmodems/archive-sixth/msg02637.html
To enable dialout without Root permission do:
$ su - root (not for Ubuntu)
chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
chmod a+x /usr/sbin/pppd
Checking settings of: /etc/ppp/options
lock
In case of a message like:
Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
Read Modem/DOCs/YourSystem.txt concerning other COMM channels: eth0
virbr0 wlan0 wmaster0
Which can interfere with Browser naviagation.
Don't worry about the following, it is for experts should trouble
shooting be necessary.
==========================================================
Checking for modem support lines:
--------------------------------------
/device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
Within /etc/udev/ files:
Within /etc/modprobe.conf files:
Within any ancient /etc/devfs files:
Within ancient kernel 2.4.n /etc/module.conf files:
--------- end modem support lines --------
