Resending as Plain text. Sorry. :\ ---------- Forwarded message ---------- From: Rob Kendrick <robkendrick@xxxxxxxxx> Date: Thu, Oct 16, 2008 at 2:17 AM Subject: Re: third try still in need of help To: Mark Hinchliff <mfh@xxxxxxxxxxxx> Cc: discuss@xxxxxxxxxxxxx Hi Mark, I'm in the same boat with the AGRSM, but with a Lucent faxmodem. Did you run the ./configure? If so, try a modprobe agrmodem and modprobe agrserial and see if that helps. Once done, you should be able to check /dev for a ttyAGS3 device. That's where I'm stuck. I can get the device, but HylaFAX can't get the speed of the port; freezes at probing. I hope this helps a bit. Keep us posted. Take care, Rob Kendrick On Thu, Oct 16, 2008 at 1:10 AM, Mark Hinchliff <mfh@xxxxxxxxxxxx> wrote: > > Hello, > > This is my third post. This time I worked of the agrsm drivers howto. > > I downloaded an installed on my desktop agrsm-ubuntu8.04.1-2.6.24-19-generic. > > Following the howto instructions, I then skipped to its step 7. Step 7.1 went fine. > > At step 7.2. "sudo cp *.ko/lib/modules/`uname -r`/extra/", > I received the following message: > > cp: missing destination file operand after '*.ko/lib/modules/2.6.24-19-generic/extra/' > > I wasn't sure how to proceed. > If it's any help, I also took step 1 in the howto instructions for agrsm drivers. I ran the command "cat /proc/asound/version", and I received exactly the output that appears in bold below in the howto, that is, the two lines that begin "Advanced Linux . . .". > > I hope someone will be able to look at my three posts today, and suggest a way forward. > > Thanks very much, > > Mark > > > >