Matias, Read the troubleshooting section of the agrsm_howto.txt On Wed, Sep 24, 2008 at 12:38 PM, Matías Gutiérrez<matiasgutierrezreto@xxxxxxxxx> wrote:> Thanks Marvin. I'll try as soon as I can.> Now I switched my box to Lenny i386. I compiled the drivers using this> tarball:>> http://linmodems.technion.ac.il/packages/ltmodem/sv92/agrsm-20080203.tar.gz>> I followed the procedure, don't see any error when I do modprobe in> /var/log/messages. Device /dev/ttyAGS3 is created, but I don't have response> from modem using minicom or configuring ppp with pppconfig.> May be something related to acpi?>> Regards,> Matías>>> Marvin Stodolsky escribió:>>>> Matias,>>>> If you compile martian_drv.ko as 64 bit and martian_modem as 32 bit,>> the two will work together on a x86_64 system.>>>> MarvS>>>> On Tue, Sep 23, 2008 at 8:07 AM, Matías Gutiérrez>> <matiasgutierrezreto@xxxxxxxxx> wrote:>>>>>>>> Marvin,>>>>>> Thanks for your answer!>>> Well, bad luck. I think I will switch my distro back to i386>>> architecture. I>>> have another modem which I was using with "martian" but I think I'll have>>> the same problem trying to compile martian on x86-64.>>>>>> Thanks and congratulations for the job you've been doing on linmodems.>>> Matías>>>>>>>>> Marvin Stodolsky escribió:>>>>>>>>>>> Matias,>>>>>>>> Re: Is it possible to compile or use the driver in AMD-64 bits?>>>> Sadly no. There are precompiled 32 bit components which are not>>>> compatible with a 64 bit compile. LSI/Agere has not responded to a>>>> request to provide these in 64 bit format.>>>>>>>> MarvS>>>> scanModem maintainer>>>>>>>> On Mon, Sep 22, 2008 at 12:59 PM, Matías Gutiérrez>>>> <matiasgutierrezreto@xxxxxxxxx> wrote:>>>>>>>>>>>>>>>>>> Hello all!>>>>>>>>>> I got a new box with and amd processor. So I'm using Debian Lenny for>>>>> architecture AMD-64.>>>>> In that box I have a modem with Agere chipset from the vendor Advantek.>>>>> The info in lspci and scanmodem (I'm at work now and I don't have my>>>>> modemdata file with me, but I'll post when I get home if necessary).>>>>>>>>>> Modem ID:>>>>>>>>>> 11c1:0620 11c1:0620 Communication controller: Agere Systems Unknown>>>>> device>>>>> 0620>>>>>>>>>> As I found after some googling I downloaded the driver from here:>>>>>>>>>>>>>>>>>>>> http://linmodems.technion.ac.il/packages/ltmodem/sv92/agrsm-20080203.tar.gz>>>>>>>>>>>>>>> At my job I just tested compilling the driver in a Lenny i386>>>>> architecture.>>>>> Everything went ok.>>>>>>>>>> My question is: Is it possible to compile or use the driver in AMD-64>>>>> bits?>>>>> I red that some drivers could work in 64 bits if they are compilled in>>>>> 32>>>>> bits mode... Is that so? How could I do it?>>>>>>>>>> Thanks in advance for the help,>>>>> Matías>>>>>>>>>>>>>>>>>>>>>>>
