Hi there,
My laptop is an ACER 2920Z. It has an internal V.92 56K Modem.
I have tried everything but cannot figure out how to make it work.
Can anybody assist?
Sincerely.
G. Kaloutas.
Only plain text email is forwarded by the Discuss@xxxxxxxxxxxxx List Server,
as HTML can contain viruses. Use as the email Subject Line:
YourName, YourCountry kernel 2.6.24-19-generic
With this Subject Line cogent experts will be alerted, and useful case names left in the Archive.
YourCountry will enable Country specific guidance. Linux experts in YourCountry
can be found through: http://www.linux.org/groups/index.html.
They will know your Country's modem code, which may be essential for dialup service.
Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org
-------------------------- System information ----------------------------
CPU=i686,
Linux version 2.6.24-19-generic (buildd@terranova) (gcc version 4.2.3 (Ubuntu 4.2.3-2ubuntu7)) #1 SMP Fri Jul 11 23:41:49 UTC 2008
scanModem update of: 2008_07_12
The modem symbolic link is /dev/modem -> ttySL0
There are no blacklisted modem drivers in /etc/modprobe* files
Attached USB devices are:
ID 064e:a101 Suyin Corp.
ID 0bda:0158 Realtek Semiconductor Corp.
ID 04f2:0522 Chicony Electronics Co., Ltd
USB modems not recognized
For candidate card in slot 00:1b.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:1b.0 8086:284b 1025:0135 Audio device: Intel Corporation 82801H
Modem interrupt assignment and sharing:
23: 694 693 IO-APIC-fasteoi HDA Intel
--- Bootup diagnostics for card in PCI slot 00:1b.0 ----
[ 36.353266] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 23
[ 36.353298] PCI: Setting latency timer of device 0000:00:1b.0 to 64
===== Advanced Linux Sound Architecture (ALSA) diagnostics =====
The ALSA packages provide audio support and also drivers for some modems.
ALSA diagnostics are written during bootup to /proc/asound/ folders.
PCI slot 00:1b.0 has a High Definition Audio Card
The drivers are in the kernel modules tree at:
/lib/modules/2.6.24-19-generic/lib/modules/2.6.24-19-generic/ubuntu/sound/alsa-driver/pci/hda/snd-hda-intel.ko
/lib/modules/2.6.24-19-generic/kernel/sound/pci/hda/snd-hda-intel.ko
The ALSA verion is 1.0.15
The modem cards detected by "aplay -l" are: None
The /proc/asound/pcm file reports:
-----------------------
00-02: ALC268 Analog : ALC268 Analog : capture 1
00-01: ALC268 Digital : ALC268 Digital : playback 1
00-00: ALC268 Analog : ALC268 Analog : playback 1 : capture 1
about /proc/asound/cards:
------------------------
0 [Intel ]: HDA-Intel - HDA Intel
HDA Intel at 0xfc200000 irq 23
=== Finished firmware and bootup diagnostics, next deducing cogent software. ===
A candidate modem is not evident among the PCI devices:
------------------------------------------------
00:02.0 VGA compatible controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controller (rev 03)
00:02.1 Display controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controller (rev 03)
00:1b.0 Audio device: Intel Corporation 82801H (ICH8 Family) HD Audio Controller (rev 03)
00:1f.1 IDE interface: Intel Corporation 82801HBM/HEM (ICH8M/ICH8M-E) IDE Controller (rev 03)
00:1f.2 IDE interface: Intel Corporation 82801HBM/HEM (ICH8M/ICH8M-E) SATA IDE Controller (rev 03)
00:1f.3 SMBus: Intel Corporation 82801H (ICH8 Family) SMBus Controller (rev 03)
02:00.0 Ethernet controller: Broadcom Corporation NetLink BCM5787M Gigabit Ethernet PCI Express (rev 02)
04:00.0 Ethernet controller: Atheros Communications Inc. AR242x 802.11abg Wireless PCI Express Adapter (rev 01)
------------------------------------------------
with USB and bridge devices not displayed.
If your modem is connected by an external serial cable,
or mounted internally on an ISA card, scanModem would not access it.
Try with Root permission
$ sudo wvdialconf /etc/wvdial.conf
to detect these modem types and some USB modems.
If the detection is successful, read the DOCs/wvdial.txt .
Edit the /etc/wvdial.conf with Root permission:
sudo gedit /etc/wvdial.conf
will be able to dial out with Root permission:
sudo wvdial
Many modems for which scanModem fails have Conexant chips.
From http://www.linuxant.com/drivers/modemident.php
get the ListModem tool, which will report on Conexant chipset modems
If the above tests fail, please provide any independent information available on your modem.
If an alternative boot into Microsoft windows can be done, do mouse
clicks on:
Start > Settings > Control Panel > Classical View (for Window XP) > System
> Hardware > Device Manager > Modems > Click on the + > Modem. Double click to
expand the graphic. Manufacturer information may be displayed. For example, CXT
stands for Conexant. Click the Diagnostics Tab. Record any hardware ID or vendor
and device information. From the Driver Details TAB, copy out the VENdor and DEVice information.
Next do the Query Modem and record the ATI specifications displayed such as:
ATI3 - Agere SoftModem Version 2.1.22
ATI5 - 2.1.22, AMR Intel MB, AC97 ID:SIL REV:0x27
Try to identify the modem setup file, with name perhaps MODEM.INF.
If may contain chipset Vendor informaton.
The /proc/asound/ audio+modem diagostics are being copied.
Finished copy to Modem/ALSAroot.tgz
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset not detected on
NAME="Audio device: Intel Corporation 82801H "
CLASS=0403
PCIDEV=8086:284b
SUBSYS=1025:0135
IRQ=23
HDA=8086:284b
SOFT=8086:284b.HDA
High Definition Audio (HDA) cards MAY host a modem chip in their Subsystem,
and many are supported by the ALSA audio+modem driver snd-hda-intel
A modem was not detected on HDA card 8086:284b.
If another modem card is present, then most likely 8086:284b does not host a modem.
If another modem card has not been detected, then possibilities are:
1) A Conexant modem chip is present on 8086:284b, as Conexant chips
are frequently not detectable by ALSA diagnostics
2) The modem may be of the older non-PCI Controller Chipset (hardware) type.
Try detection with Root permission:
sudo wvdialconf /etc/wvdial.conf
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801H
Primary device ID: 8086:284b
Subsystem PCI_id 1025:0135
Softmodem codec or chipset from diagnostics:
from Archives:
Support type needed or chipset:
Support can likely be achieved through two mutually exclusive alternatives:
1) The hsfmodem software for Conexant chipset modems: Read DOCs/Conexant.txt
The following ALSA alternative CANNOT work with Conexant modems.
2) An ALSA modem driver plus slmodemd. Read DOCs/Smartlink.txt for details, and
to test get the package SLMODEMD.gcc4.2.tar.gz from:
http://linmodems.technion.ac.il/packages/smartlink/
----------------end Softmodem section --------------
Writing DOCs/Intel.txt
For owners of a Dell PCs with Conexant HSF modems, a driver source package with full speed enabled is available, but requires driver compiling. Read DOCs/Conexant.txt
From http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php
download hsfmodem-7.68.00.07full_k2.6.24_19_generic_ubuntu_i386.deb.zip
Under Linux unpack with:
$ unzip hsfmodem*.zip
Then install with:
$ sudo dpkg -i hsfmodem*.deb
Subsequently, the modem should be found with
$ sudo wvdialconf /etc/wvdial.conf
Edit in your personal information with:
$ sudo gedit /etc/wvdial.conf
and try dialing out with:
$ sudo wvdial.
See DOCs/Testing.txt for details.
Read DOCs/Conexant.txt
Writing DOCs/Conexant.txt
Writing DOCs/Smartlink.txt
============ end Smartlink section =====================
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.2.3
and the compiler used in kernel assembly: 4.2.3
Minimal compiling resources appear complete:
make utility - /usr/bin/make
Compiler version 4.2
linuc_headers base folder /lib/modules/2.6.24-19-generic/build
However some compilations and executable functions may need additional files,
in the FileNames.h (so called kernel "h"eaders) collection installed in /usr/include/ .
For martian_modem, additional required packages are n. The also required headers of package libc6 are commonly installed by default.
Compiling hsfmodem drivers does require linux-libc-dev and libc6-dev packages, for kernels 2.6.24 and later versions.
In not included on your install CD, search for them at http://packages.ubuntu.com
or comparable Repository for other Linux distros.
When compiling ALSA drivers, the utility "patch" will also be needed.
Compressed files at: /usr/src/sl-modem.tar.bz2
If a driver compilation fails, with message including some lack of some FileName.h (stdio.h for example), then
Some additional kernel-header files need installation to /usr/include. The minimal additional packages are libc6-dev
and any of its dependents, under Ubuntu linux-libc-dev
If an alternate ethernet connection is available,
$ apt-get update
$ apt-get -s install linux-kernel-devel
will install needed packages.
For Debian/Ubuntu related distributions, run the following command to display the needed package list:
Otherwise packages have to be found through http://packages.ubuntu.com
Once downloaded and transferred into a Linux partition,
they can be installed alltogether with:
$ sudo dpkg -i *.deb
Checking pppd properties:
-rwsr-xr-- 1 root dip 269256 2007-10-04 22:57 /usr/sbin/pppd
In case of an "error 17" "serial loopback" problem, see:
http://linmodems.technion.ac.il/linmodems/archive-sixth/msg02637.html
To enable dialout without Root permission do:
$ su - root (not for Ubuntu)
sudo chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
sudo chmod a+x /usr/sbin/pppd
Checking settings of: /etc/ppp/options
asyncmap 0
noauth
crtscts
lock
hide-password
modem
proxyarp
lcp-echo-interval 30
lcp-echo-failure 4
noipx
In case of a message like:
Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
Read Modem/DOCs/YourSystem.txt concerning other COMM channels: ath0 eth0 wifi0
Which can interfere with Browser naviagation.
Don't worry about the following, it is for experts should trouble shooting be necessary.
==========================================================
# start/stop the daemon when the USB modem is connected
KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
Checking for modem support lines:
--------------------------------------
/device/modem symbolic link: lrwxrwxrwx 1 root root 6 2008-07-19 19:33 /dev/modem -> ttySL0
slmodemd created symbolic link /dev/ttySL0:
Within /etc/udev/ files:
/etc/udev/rules.d/030_sl-modem-daemon.rules:# start/stop the daemon when the USB modem is connected
/etc/udev/rules.d/030_sl-modem-daemon.rules:KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
/etc/udev/sl-modem-daemon.rules:# start/stop the daemon when the USB modem is connected
/etc/udev/sl-modem-daemon.rules:KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
Within /etc/modprobe.conf files:
/etc/modprobe.d/blacklist-modem:# Uncomment these entries in order to blacklist unwanted modem drivers
/etc/modprobe.d/blacklist-modem:# blacklist snd-atiixp-modem
/etc/modprobe.d/blacklist-modem:# blacklist snd-via82xx-modem
/etc/modprobe.d/alsa-base:options snd-atiixp-modem index=-2
/etc/modprobe.d/alsa-base:options snd-via82xx-modem index=-2
/etc/modprobe.d/sl-modem-daemon.modutils:install slamr modprobe --ignore-install ungrab-winmodem ; modprobe --ignore-install slamr; test -e /dev/slamr0 || (/bin/mknod -m 660 /dev/slamr0 c 242 0 2>/dev/null && chgrp dialout /dev/slamr0)
Within any ancient /etc/devfs files:
Within ancient kernel 2.4.n /etc/module.conf files:
--------- end modem support lines --------
