Heidi, The Conexant package no longer seems relevant, and this list generally does not support wireless. But doing a Google search again, there is NEW good news for your: ID 0c88:180a Kyocera Wireless Corp. http://anastasis.googlepages.com/kpc680onubuntulinuxinstructions with solution from Sergiy Zaschipas, http://www.linkedin.com/pub/5/215/418 Basically, to kernel source code, drivers/usb/serial/airprime.c there must be added a line recognizing { USB_DEVICE(0x0c88, 0x180a) } No additional capabilties are thereby added, to those supporting the prior chipset in this series: 0x0c88, 0x17da Then a replacement kernel+modules compiled and installed. http://www.intomobile.com/2007/11/21/kyocera-kpc680-ev-do-rev-a-expresscard-lands-on-verizon.html has the ongoing discussion between others with this problem under Ubuntu kernel 2.6.24-19 $ grep AIRPRIME /boot/config-2.6.24-19-generic CONFIG_USB_SERIAL_AIRPRIME=m -------- shows that general AirPrime wireless support is enabled already, so only the recognition code { USB_DEVICE(0x0c88, 0x180a) } is necessary to enable the necessary recognition of the KPC680 wireless. The compiled driver that must be replaced is at: /lib/modules/2.6.24-19-generic/kernel/drivers/usb/serial/airprime.ko I've searched through http://www.kernel.org/pub/linux/kernel/v2.6/ChangeLog-2.6.26 and this change is not in the new 2.6.26 source code release, or in the new release being developed: http://www.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.26-rc8/2.6.26-rc8-mm1/announce.txt Thus this fix must for now be done manually. This is beyond your current experience. May give it a try for you, but it may take a few days. MarvS On Sun, Jul 13, 2008 at 1:53 PM, Heidi Ann <adonis12490@xxxxxxxxxxx> wrote: > Hi - > > Anyone out there have ANY suggestions of this express card getting to > work under Hardy Heron??? Have tried everything for the past month - no > success. Here's terminal read out for wvdial: > > heidiann@heidiann-laptop:~$ sudo wvdialconf /etc/wvdial.conf > [sudo] password for heidiann: > Editing `/etc/wvdial.conf'. > > Scanning your serial ports for a modem. > > Modem Port Scan<*1>: Scanning ttySHSF0 first, /dev/modem is a link to > it. > Modem Port Scan<*1>: SHSF0 S0 S1 S2 S3 SHSF1 SHSF2 SHSF3 > Modem Port Scan<*1>: SHSF4 SHSF5 SHSF6 SHSF7 > > > Sorry, no modem was detected! Is it in use by another program? > Did you configure it properly with setserial? > > Please read the FAQ at http://open.nit.ca/wiki/?WvDial > > If you still have problems, send mail to <wvdial-list@xxxxxxxxxxxx>. > heidiann@heidiann-laptop:~$ > > > Here's readout from hsfmodem: > > heidiann@heidiann-laptop:~$ sudo dpkg -i hsfmodem*.deb > (Reading database ... 156508 files and directories currently installed.) > Preparing to replace hsfmodem 7.68.00.11full-k2.6.24-19-generic-1.ubuntu > (using hsfmodem_7.68.00.11full_k2.6.24_19_generic_ubuntu_i386.deb) ... > Unpacking replacement hsfmodem ... > dpkg: dependency problems prevent configuration of hsfmodem: > hsfmodem depends on alsa-driver-linuxant; however: > Package alsa-driver-linuxant is not configured yet. > dpkg: error processing hsfmodem (--install): > dependency problems - leaving unconfigured > Errors were encountered while processing: > hsfmodem > > > > I already tried install of alsa-driver-linuxant for DEB, and it says > package already installed. Did a reinstall - no luck there either. > Tried the patch - no luck. After all this, my sound is gone. > > Desperate for help. > Heidi > > > > > > >
