Marvin, With the line Init2 = AT&F H0 L3 I still have the same behaviour : WvDial<*1>: Looks like a password prompt. WvDial<*1>: Sending: (password) WvDial Modem<*1>: NO CARRIER WvDial<Notice>: Don't know what to do! Starting pppd and hoping for the best. WvDial<Notice>: Starting pppd at Sun Apr 20 09:05:53 2008 WvDial<Notice>: Pid of pppd: 6208 WvDial<*1>: Using interface ppp0 WvDial<*1>: pppd: 8�[06][08]��[06][08] WvDial<*1>: pppd: 8�[06][08]��[06][08] WvDial<*1>: pppd: 8�[06][08]��[06][08] WvDial<*1>: pppd: 8�[06][08]��[06][08] WvDial<*1>: pppd: 8�[06][08]��[06][08] WvDial<*1>: Disconnecting at Sun Apr 20 09:06:24 2008 WvDial<*1>: The PPP daemon has died: A modem hung up the phone (exit code = 16) Other ideas? Thanks Le samedi 19 avril 2008 à 11:58 -0400, Marvin Stodolsky a écrit : > Sebek > > Try using in wvdial.conf > Init2 = AT&F H0 L3 > > It may be better adapted to your IP then, the standard > Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 > > MarvS > > > On Sat, Apr 19, 2008 at 9:18 AM, sebek <sebeeek@xxxxxxxxx> wrote: > > Hello, > > > > Quite a time ago, I made my modem work thanks to advices from this list > > with module snd_intel8x0m and slmodemd : > > $ sudo slmodemd -d 1 -c OMAN -a modem:1 > > [...] > > Use `/dev/ttySL0' as modem device, Ctrl+C for termination. > > > > I am then launching the connection with network manager. > > > > As I am doing some debug about low performance, I would like to use > > wvdial instead of network-manager (more verbose). > > > > However, the wvdial is not going well, the ppp0 interface is never up. > > Do you know what could be wrong with my wvdial.conf ? I have read > > wvdial.txt generated by scanModem but can not see any error. > > Details below. > > > > KO case : > > sebek@bourdon:~$ sudo wvdial > > WvDial<*1>: Modem initialized. > > WvModem<*1>: Cannot get information for serial port. > > WvDial<*1>: Initializing modem. > > WvDial<*1>: Sending: ATZ > > WvDial Modem<*1>: ATZ > > WvDial Modem<*1>: OK > > WvDial<*1>: Sending: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 > > WvDial Modem<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 > > WvDial Modem<*1>: OK > > WvDial<*1>: Modem initialized. > > WvDial<*1>: Sending: ATDT122 > > WvDial<*1>: Waiting for carrier. > > WvDial Modem<*1>: ATDT122 > > WvDial Modem<*1>: CONNECT 40000 > > WvDial<*1>: Carrier detected. Waiting for prompt. > > WvDial Modem<*1>: Authorized Access Only > > WvDial Modem<*1>: This system is the property of YemenNet PTC > > WvDial Modem<*1>: Disconnect IMMEDIATELY if you are not an authorized > > user! > > WvDial Modem<*1>: User Access Verification > > WvDial Modem<*1>: Password: > > WvDial<*1>: Looks like a password prompt. > > WvDial<*1>: Sending: (password) > > WvDial Modem<*1>: Password: > > WvDial<*1>: Looks like a password prompt. > > WvDial<*1>: Sending: (password) > > WvDial Modem<*1>: NO CARRIER > > WvDial<Notice>: Don't know what to do! Starting pppd and hoping for the > > best. > > WvDial<Notice>: Starting pppd at Sat Apr 19 16:15:42 2008 > > WvDial<Notice>: Pid of pppd: 8238 > > WvDial<*1>: Using interface ppp0 > > WvDial<*1>: pppd: H�[06][08]��[06][08] > > WvDial<*1>: pppd: H�[06][08]��[06][08] > > Apr 19 16:15:42 bourdon pppd[8238]: pppd 2.4.4 started by root, uid 0 > > Apr 19 16:15:42 bourdon pppd[8238]: Using interface ppp0 > > Apr 19 16:15:42 bourdon pppd[8238]: Connect: ppp0 <--> /dev/pts/3 > > WvDial<*1>: pppd: H�[06][08]��[06][08] > > WvDial<*1>: pppd: H�[06][08]��[06][08] > > WvDial<*1>: pppd: H�[06][08]��[06][08] > > Apr 19 16:16:39 bourdon pppd[8238]: LCP: timeout sending > > Config-Requests > > Apr 19 16:16:39 bourdon pppd[8238]: Connection terminated. > > Apr 19 16:16:39 bourdon pppd[8238]: Modem hangup > > Apr 19 16:16:39 bourdon pppd[8238]: Exit. > > WvDial<*1>: Disconnecting at Sat Apr 19 16:16:39 2008 > > WvDial<*1>: The PPP daemon has died: A modem hung up the phone (exit > > code = 16) > > > > but there is never any ppp interface up and then pppd hangs up. > > Here is the wvdial.conf : > > > > sebek@bourdon:~$ cat /etc/wvdial.conf > > [Dialer Defaults] > > Phone = 122 > > Username = XXXXX > > Password = XXXXX > > New PPPD = yes > > Init1 = ATZ > > Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 > > Modem Type = Analog Modem > > Baud = 460800 > > New PPPD = yes > > Modem = /dev/ttySL0 > > ISDN = 0 > > Carrier Check = no > > > > > > And for reference, what happens with network-manager (OK case) : > > Apr 19 15:23:55 bourdon pppd[7484]: pppd 2.4.4 started by root, uid 0 > > Apr 19 15:23:55 bourdon kernel: [ 5260.788000] PPP generic driver > > version 2.4.2 > > Apr 19 15:23:55 bourdon pppd[7484]: Using interface ppp0 > > Apr 19 15:23:55 bourdon pppd[7484]: Connect: ppp0 <--> /dev/pts/3 > > Apr 19 15:24:31 bourdon pppd[7484]: Terminating on signal 15 > > Apr 19 15:24:31 bourdon pppd[7484]: Connection terminated. > > Apr 19 15:24:31 bourdon pppd[7484]: Exit. > > Apr 19 15:24:37 bourdon pppd[7517]: pppd 2.4.4 started by root, uid 0 > > Apr 19 15:24:38 bourdon chat[7556]: timeout set to 60 seconds > > Apr 19 15:24:38 bourdon chat[7556]: abort on (ERROR) > > Apr 19 15:24:38 bourdon chat[7556]: abort on (BUSY) > > Apr 19 15:24:38 bourdon chat[7556]: abort on (VOICE) > > Apr 19 15:24:38 bourdon chat[7556]: abort on (NO CARRIER) > > Apr 19 15:24:38 bourdon chat[7556]: abort on (NO DIALTONE) > > Apr 19 15:24:38 bourdon chat[7556]: abort on (NO DIAL TONE) > > Apr 19 15:24:38 bourdon chat[7556]: abort on (NO ANSWER) > > Apr 19 15:24:38 bourdon chat[7556]: send (ATZ^M) > > Apr 19 15:24:38 bourdon chat[7556]: send (AT&FH0L3^M) > > Apr 19 15:24:38 bourdon chat[7556]: expect (OK) > > Apr 19 15:24:38 bourdon chat[7556]: ATZ^M^M > > Apr 19 15:24:38 bourdon chat[7556]: OK > > Apr 19 15:24:38 bourdon chat[7556]: -- got it > > Apr 19 15:24:38 bourdon chat[7556]: send (ATDT122^M) > > Apr 19 15:24:38 bourdon chat[7556]: timeout set to 75 seconds > > Apr 19 15:24:38 bourdon chat[7556]: expect (CONNECT) > > Apr 19 15:24:38 bourdon chat[7556]: ^M > > Apr 19 15:24:38 bourdon chat[7556]: AT&FH0L3^M^M > > Apr 19 15:24:38 bourdon chat[7556]: OK^M > > Apr 19 15:24:38 bourdon chat[7556]: ATDT122^M^M > > Apr 19 15:25:10 bourdon chat[7556]: CONNECT > > Apr 19 15:25:10 bourdon chat[7556]: -- got it > > Apr 19 15:25:10 bourdon pppd[7517]: Serial connection established. > > Apr 19 15:25:10 bourdon pppd[7517]: Using interface ppp0 > > Apr 19 15:25:10 bourdon pppd[7517]: Connect: ppp0 <--> /dev/ttySL0 > > Apr 19 15:25:12 bourdon pppd[7517]: PAP authentication succeeded > > Apr 19 15:25:12 bourdon kernel: [ 5337.828000] PPP BSD Compression > > module registered > > Apr 19 15:25:12 bourdon kernel: [ 5337.920000] PPP Deflate Compression > > module registered > > Apr 19 15:25:13 bourdon pppd[7517]: local IP address 82.114.168.53 > > Apr 19 15:25:13 bourdon pppd[7517]: remote IP address 82.114.168.1 > > Apr 19 15:25:13 bourdon pppd[7517]: primary DNS address 65.162.184.33 > > Apr 19 15:25:13 bourdon pppd[7517]: secondary DNS address 65.162.184.34 > > > > > > > >
