Re: Modem

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Dear Antonio, dear MarvS,

thank you for help. I installed SLMODEMD.gcc4.1.tar.gz.
The command
$ slmodemd --help
worked nicely, but the commands
$ sudo slmodemd .c GERMANY --alsa slmodemd_device
or
$ sudo slmodemd .c USA --alsa slmodemd_device
both resultet in:
error: mixer setup: Off-hook switch not found
for card hw:0 ALSA lib pcm.c:2144:(snd_pcm_
open_noupdate) Unknown PCM slmodem_device
error: alsa setup: cannot open playback device
'slmodemd_device': No such file or directory
error: cannot setup device 'slmodemd_device'

As Marvin suggests, I will now install
Conexant modem driver.

Thank you
 Rainer


Marvin Stodolsky wrote:
> Ranier,
>
> Most likely it is a Conexant modem.  Run:
>
>  ./scanModem test 8086:284b 17aa:20ac
> this fakes a Conexant modem.
> Follow the ModemData.txt  guidance for installing the hsfmodem package
> from www.linuxant.com
>
> MarvS


Antonio Olivares wrote:

Dr. Rainer,

This is an either or case
\begin{"}
 -----------------------------------------
Support type needed or chipset:

Support can likely be achieved through two mutually exclusive alternatives:
1) The hsfmodem software for Conexant chipset modems: Read Conexant.txt
The following ALSA alternative CANNOT work with Conexant modems.

2) An ALSA modem driver plus slmodemd.  Read Smartlink.txt for details, and
to test get the package SLMODEMD.gcc4.1.tar.gz from:
       http://linmodems.technion.ac.il/packages/smartlink/

----------------end Softmodem section --------------

Writing Intel.txt

For owners of a Dell PCs with Conexant HSF modems, a driver source
package with full speed enabled is available, but requires driver
compiling. Read Conexant.txt

 Read Conexant.txt

Writing Conexant.txt

Writing Smartlink.txt
\end{"}

Maybe Marv can give you better advice.  Those are then only options.

Regards,

Antonio


On Feb 6, 2008 9:37 AM, Dr. Rainer Wawarta <rainer.wawarta@xxxxxx> wrote:

Dear MarvS,

first I tried to connect to freenet.de with an external
ELSA modem 33.6K, that I bought in 1996 and is used
with a Windows 95, Pentium 0.1 GHz 32MB PC normally.
The Linux-PC dialed correctly, but the connection did
not hold.
Then I downloded the scanModem tool with my Windows ME PC
and transferred it to the Linux PC with a burned CD
The tool shows only the Intel PCI Modem,
which is  56K and better for use, but did not
show the 33.6K Modem. As
suggested in the ModemData file I downloded
SLMODEMD.gcc4.l.ter.gz and did not know what to
do next, thats why I asked for help. I couldn´t
send the Modemdata file, because the Linux-PC has no
hardware yet to burn CD nor write any floppies.

Now I bought a USB-Stick and can send you the file.
I have installed the SLMODEMD.gcc4.l.ter.gz
with chmod and copied it into the location
/usr/sbin.
As suggested, I have searched for other SLMODEMD,
and found only the newly installed one.

What can I do next to use the 56K Modem ?
Thanks a lot
 Rainer



Marvin Stodolsky wrote:

Ranier,

Browse http://linmodems.technion.ac.il and  download scanModem.gz .
Within a Linux partition
   gunzip scanModem.gz
To make it executable:
   chmod +x scanModem
Run diagnositics with:
   ./scanModem
Only the ouput ModemData.txt should be sent to Discuss@xxxxxxxxxxxxx
--------
The entire  ModemData.txt is needed before we can help

MarvS

On Feb 5, 2008 4:30 PM, Dr. Rainer Wawarta <rainer.wawarta@xxxxxx> wrote:


Hello !

I am using Ubuntu Linux 7.10 version 2.6.22-14-generic
(build@palmer) (gcc version 4.1.3   2007 09 29  (prerelease)
Ubuntu 4.1.2-16 ubuntu 2) #1 SMP Sun Oct 14 23:05:12 GMT
2007, that contains ALSA version 1.0.14 on a
PC Celeron 2,6 GHz 1024 MHz as single OS
with a Modem Audio device: Intel Corporatioon 82801G
HDA Intel at Oxfdff 8000 irq 19
PCI-Slot 00:1b.0, PCI-ID 8086:27d4, Subsystem 105b:0ccd
00-01: ALC861VD Digital: ALC861VD Digital playback1
00-00: ALC861VD Analog: ALC861VD Analog playback1: capture2
- Modem interrupt assignment and sharing -
19: 320798 IO-APIC-fasted uhci_hcd:usb4, HDA Intel, eth0,
i915@pci: 0000:00:02.0
- Bootup diagnostics for card in PCI slot 00:1b.0 -
[34.632174] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI
16 (level, low) -> IRQ 19
[34.632200]PCI: Setting latency timer of device 0000:00:1b.0 to 64

At the moment I cannot connect to the Internet with the modem.
I am used to MS-DOS 3.3, Windows 95 and Windows ME.

I have downloaded SLOMODEMD.gcc4.1.tar.gz through Netscape
and Windows ME on another PC and transferred it to the
desktop of the Ubuntu PC.
Was this correct ? And what will I have to do now ?









Only plain text email is forwarded by the  Discuss@xxxxxxxxxxxxx List Server,
as HTML can contain viruses. Use as the email Subject Line:
          YourName, YourCountry  kernel 2.6.22-14-generic
With this Subject Line cogent experts will be alerted, and useful case names left in the Archive.
YourCountry will enable Country specific guidance. Your contry's local Linux experts
can be found through: http://www.linux.org/groups/index.html.
They will know your Country's modem code, which may be essential for dialup service.
Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org
--------------------------  System information ----------------------------
CPU=i686,
Linux version 2.6.22-14-generic (buildd@palmer) (gcc version 4.1.3 20070929 (prerelease) (Ubuntu 4.1.2-16ubuntu2)) #1 SMP Sun Oct 14 23:05:12 GMT 2007
scanModem update of:  2008_01_22


There are no blacklisted modem drivers in /etc/modprobe*  files
PCI slot 00:1b.0 has a High Definition Audio Card

The Advanced Linux Sound Architecture (ALSA) packages providing audio support,
also includes drivers for some modems. The ALSA diagnostics are written during
bootup to /proc/asound/ folders.

The /proc/asound/ audio+modem diagostics are being copied.
Finished copy to Modem/ALSArainer.tgz

The ALSA verion is 1.0.14
The modem cards detected by "aplay -l"  are:


The /proc/asound/pcm file reports:
-----------------------
00-01: ALC861VD Digital : ALC861VD Digital : playback 1
00-00: ALC861VD Analog : ALC861VD Analog : playback 1 : capture 2

about /proc/asound/cards:
------------------------
0 [Intel          ]: HDA-Intel - HDA Intel
                     HDA Intel at 0xfdff8000 irq 19

USB modem not detected by lsusb

For candidate card in slot 00:1b.0, firmware information and bootup diagnostics are:
PCI slot       PCI ID          SubsystemID     Name
----------     ---------       ---------       --------------
00:1b.0        8086:27d8       105b:0ccd       Audio device: Intel Corporation 82801G

Modem interrupt assignment and sharing:
19:     320798   IO-APIC-fasteoi   uhci_hcd:usb4, HDA Intel, eth0, i915@pci:0000:00:02.0
--- Bootup diagnostics for card in PCI slot 00:1b.0 ----
[   34.632174] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 16 (level, low) -> IRQ 19
[   34.632200] PCI: Setting latency timer of device 0000:00:1b.0 to 64


=== Finished modem firmware and bootup diagnostics section. ===
=== Next deducing cogent software ===



For candidate modem in PCI bus:  00:1b.0
  Class 0403: 8086:27d8 Audio device: Intel Corporation 82801G
     Primary PCI_id  8086:27d8
   Subsystem PCI_id  105b:0ccd
   Softmodem codec or chipset from diagnostics:
                              from    Archives:


Lacking a dsp (digital signal processing) chip, the modem is a software
intensive or "softmodem" type. Its primary controller manages the traffic
with the CPU. But the software needed is specified in the Subsystem.
-----------------------------------------
Support type needed or chipset:

Support can likely be achieved through two mutually exclusive alternatives:
1) The hsfmodem software for Conexant chipset modems: Read Conexant.txt
The following ALSA alternative CANNOT work with Conexant modems.

2) An ALSA modem driver plus slmodemd.  Read Smartlink.txt for details, and
to test get the package SLMODEMD.gcc4.1.tar.gz from:
       http://linmodems.technion.ac.il/packages/smartlink/

----------------end Softmodem section --------------

Writing Intel.txt

For owners of a Dell PCs with Conexant HSF modems, a driver source package with full speed enabled is available, but requires driver compiling. Read Conexant.txt

Read Conexant.txt

Writing Conexant.txt

Writing Smartlink.txt
============ end Smartlink section =====================


The base of the UDEV device file system is: /dev/.udev

Versions adequately match for the compiler installed: 4.1.3
            and the compiler used in kernel assembly: 4.1.3



Minimal compiling resources appear complete:
  make utility - /usr/bin/make
  Compiler version 4.1
  linuc_headers base folder /lib/modules/2.6.22-14-generic/build

However some compilations and executable functions may need additional files,
in the FileNames.h (so called kernel "h"eaders) collection installed in  /usr/include/ .
For martian_modem, additional required packages are libc6-dev (and for Debian/Ubuntu,  linux-libc-dev). The also required headers of package libc6 are commonly installed by default.



If a driver compilation fails, with message including some lack of some FileName.h (stdio.h for example), then
Some additional kernel-header files need installation to /usr/include. The minimal additional packages are libc6-dev
and any of its dependents, under Ubuntu linux-libc-dev

If an alternate ethernet connection is available,
$  apt-get update
$  apt-get -s install linux-kernel-devel
will install needed package
For Debian/Ubuntu related distributions, run the following command to display the needed package list:

Otherwise packages have to be found through http://packages.ubuntu.com
Once downloaded and transferred into a Linux partition,
they can be installed alltogether with:
$ sudo dpkg -i *.deb


Checking pppd properties:
       -rwsr-xr-- 1 root dip 269256 2007-10-04 21:57 /usr/sbin/pppd

In case of an "error 17" "serial loopback" problem, see:
   http://phep2.technion.ac.il/linmodems/archive-sixth/msg02637.html

To enable dialout without Root permission do:
       $ su - root  (not for Ubuntu)
       sudo chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
       sudo chmod a+x /usr/sbin/pppd

Checking settings of:   /etc/ppp/options
asyncmap 0
noauth
crtscts
lock
hide-password
modem
proxyarp
lcp-echo-interval 30
lcp-echo-failure 4
noipx

In case of a message like:
  Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html


Don't worry about the following, it is for the experts
should trouble shooting be necessary.
==========================================================

Checking for modem support lines:
--------------------------------------
    /device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
    Within /etc/udev/ files:

    Within /etc/modprobe.conf files:
/etc/modprobe.d/alsa-base:options snd-atiixp-modem index=-2
/etc/modprobe.d/alsa-base:options snd-via82xx-modem index=-2
/etc/modprobe.d/blacklist-modem:# Uncomment these entries in order to blacklist unwanted modem drivers
/etc/modprobe.d/blacklist-modem:# blacklist snd-atiixp-modem
/etc/modprobe.d/blacklist-modem:# blacklist snd-via82xx-modem
    Within any ancient /etc/devfs files:

    Within ancient kernel 2.4.n /etc/module.conf files:

--------- end modem support lines --------







[Index of Archives]     [Linux Media Development]     [Asterisk]     [DCCP]     [Netdev]     [X.org]     [Xfree86]     [Fedora Women]     [Linux USB]

  Powered by Linux