thanks.. here's the output stuck again.. [root@localhost manu]# slmodemd -c AUSTRALIA --alsa hw:0,6 SmartLink Soft Modem: version 2.9.11 Jan 7 2008 07:25:57 symbolic link `/dev/ttySL0' -> `/dev/pts/1' created. modem `hw:0,6' created. TTY is `/dev/pts/1' Use `/dev/ttySL0' as modem device, Ctrl+C for termination. [root@localhost manu]# wvdial --> WvDial: Internet dialer version 1.60 --> Warning: section [Dialer Defaults] does not exist in wvdial.conf. --> Cannot open /dev/modem: No such file or directory --> Cannot open /dev/modem: No such file or directory --> Cannot open /dev/modem: No such file or directory [root@localhost manu]# wvdialconf Editing `/etc/wvdial.conf'. Scanning your serial ports for a modem. Modem Port Scan<*1>: S0 S1 S2 S3 Sorry, no modem was detected! Is it in use by another program? Did you configure it properly with setserial? Please read the FAQ at http://open.nit.ca/wiki/?WvDial If you still have problems, send mail to <wvdial-list@xxxxxxxxxxxx>. Manu Khur wrote: > > Hi All, > I am using an HP tx1320 series laptop and am unable to configure modem on > my laptop. Please advise me a procedure to install the modem. > > here is the output of modemdata.txt > > > -------------------------- System information > ---------------------------- > CPU=i686, Fedora release 8 (Werewolf) > Kernel > Linux version 2.6.23.9-85.fc8 > (kojibuilder@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx) (gcc version 4.1.2 > 20070925 (Red Hat 4.1.2-33)) #1 SMP Fri Dec 7 15:49:59 EST 2007 > scanModem update of: 2008_01_22 > > > There are no blacklisted modem drivers in /etc/modprobe* files > PCI slot 00:10.1 has a High Definition Audio Card > > The Advanced Linux Sound Architecture (ALSA) packages providing audio > support, > also includes drivers for some modems. The ALSA diagnostics are written > during > bootup to /proc/asound/ folders. > > The /proc/asound/ audio+modem diagostics are being copied. > Finished copy to Modem/ALSAroot.tgz > > The ALSA verion is 1.0.15 > The modem cards detected by "aplay -l" are: > card 0: NVidia [HDA NVidia], device 6: Si3054 Modem [Si3054 Modem] > > The /proc/asound/pcm file reports: > ----------------------- > 00-06: Si3054 Modem : Si3054 Modem : playback 1 : capture 1 > 00-01: ALC861VD Digital : ALC861VD Digital : playback 1 > 00-00: ALC861VD Analog : ALC861VD Analog : playback 1 : capture 2 > > about /proc/asound/cards: > ------------------------ > 0 [NVidia ]: HDA-Intel - HDA NVidia > HDA NVidia at 0xc0000000 irq 21 > > > The driver snd-hda-intel with its dependent drivers: > snd_hda_intel 274529 4 > snd_pcm 63685 2 snd_hda_intel,snd_pcm_oss > snd_page_alloc 11337 2 snd_hda_intel,snd_pcm > snd_hwdep 10309 1 snd_hda_intel > snd 43461 15 > snd_hda_intel,snd_seq_oss,snd_seq,snd_seq_device,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer,snd_hwdep > ---------- > provide audio + modem support for many soft modem chips residing on the > High Definition Audio (HDA) card subsystem. However modem support for some > is not yet fully implemented. > > > The driver snd-hda-intel with its dependent drivers: > snd_hda_intel 274529 4 > snd_pcm 63685 2 snd_hda_intel,snd_pcm_oss > snd_page_alloc 11337 2 snd_hda_intel,snd_pcm > snd_hwdep 10309 1 snd_hda_intel > snd 43461 15 > snd_hda_intel,snd_seq_oss,snd_seq,snd_seq_device,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer,snd_hwdep > ---------- > provide modem + audio support. > > > The modem codec file for the the HDA card is: /proc/asound/card0/codec#1 > -------------------------------------------------------- > Codec: Motorola Si3054 > Address: 1 > Vendor Id: 0x10573055 > Subsystem Id: 0x103c30bf > Revision Id: 0x100700 > Modem Function Group: 0x1 > > The audio card hosts a softmodem chip: 0x10573055 > > The modem codec file for the the HDA card is: /proc/asound/card0/codec#1 > -------------------------------------------------------- > Codec: Motorola Si3054 > Address: 1 > Vendor Id: 0x10573055 > Subsystem Id: 0x103c30bf > Revision Id: 0x100700 > Modem Function Group: 0x1 > > The audio card hosts a softmodem chip: 0x10573055 > USB modem not detected by lsusb > > For candidate card in slot 00:10.1, firmware information and bootup > diagnostics are: > PCI slot PCI ID SubsystemID Name > ---------- --------- --------- -------------- > 00:10.1 10de:026c 103c:30bf Audio device: nVidia Corporation MCP51 High > Definition Audio > > Modem interrupt assignment and sharing: > 21: 33519 2934 IO-APIC-fasteoi HDA Intel > --- Bootup diagnostics for card in PCI slot 00:10.1 ---- > ACPI: PCI Interrupt 0000:00:10.1[B] -> Link [LAZA] -> GSI 17 (level, high) > -> IRQ 21 > PCI: Setting latency timer of device 0000:00:10.1 to 64 > > > === Finished modem firmware and bootup diagnostics section. === > === Next deducing cogent software === > > > > For candidate modem in PCI bus: 00:10.1 > Class 0403: 10de:026c Audio device: nVidia Corporation MCP51 High > Definition Audio > Primary PCI_id 10de:026c > Subsystem PCI_id 103c:30bf > Softmodem codec or chipset from diagnostics: > from Archives: > > > Lacking a dsp (digital signal processing) chip, the modem is a software > intensive or "softmodem" type. Its primary controller manages the traffic > with the CPU. But the software needed is specified in the Subsystem. > ----------------------------------------- > Support type needed or chipset: > > Support can likely be achieved through two mutually exclusive > alternatives: > 1) The hsfmodem software for Conexant chipset modems: Read Conexant.txt > The following ALSA alternative CANNOT work with Conexant modems. > > 2) An ALSA modem driver plus slmodemd. Read Smartlink.txt for details, > and > to test get the package SLMODEMD.gcc4.1.tar.gz from: > http://linmodems.technion.ac.il/packages/smartlink/ > > ----------------end Softmodem section -------------- > > For owners of a Dell PCs with Conexant HSF modems, a driver source package > with full speed enabled is available, but requires driver compiling. Read > Conexant.txt > > Read Conexant.txt > > Writing Conexant.txt > > Writing Smartlink.txt > ============ end Smartlink section ===================== > > > The base of the UDEV device file system is: /dev/.udev > > Versions adequately match for the compiler installed: 4.1.2 > and the compiler used in kernel assembly: 4.1.2 > > linux-headers-2.6.23.9-85.fc8 resources needed for compiling are not > manifestly ready! > > If compiling is necessary packages must be installed, providing: > kernel-source-2.6.23.9-85.fc8 > > > If a driver compilation fails, with message including some lack of some > FileName.h (stdio.h for example), then > Some additional kernel-header files need installation to /usr/include. The > minimal additional packages are libc6-dev > and any of its dependents, under Ubuntu linux-libc-dev > > If an alternate ethernet connection is available, > $ apt-get update > $ apt-get -s install linux-kernel-devel > will install needed package > For Debian/Ubuntu related distributions, run the following command to > display the needed package list: > > Otherwise packages have to be found through http://packages.ubuntu.com > Once downloaded and transferred into a Linux partition, > they can be installed alltogether with: > $ sudo dpkg -i *.deb > > > Checking pppd properties: > -r-xr-xr-x 1 root root 312332 2006-12-01 23:54 /usr/sbin/pppd > > In case of an "error 17" "serial loopback" problem, see: > http://phep2.technion.ac.il/linmodems/archive-sixth/msg02637.html > > To enable dialout without Root permission do: > $ su - root (not for Ubuntu) > chmod a+x /usr/sbin/pppd > or under Ubuntu related Linuxes > chmod a+x /usr/sbin/pppd > > Checking settings of: /etc/ppp/options > lock > > In case of a message like: > Warning: Could not modify /etc/ppp/pap-secrets: Permission denied > see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html > > Read Modem/YourSystem.txt concerning other COMM channels: eth0 virbr0 > wlan0 wmaster0 > Which can interfere with Browser naviagation. > > Don't worry about the following, it is for the experts > should trouble shooting be necessary. > ========================================================== > > Checking for modem support lines: > -------------------------------------- > /device/modem symbolic link: > slmodemd created symbolic link /dev/ttySL0: > Within /etc/udev/ files: > /etc/udev/rules.d/50-udev-default.rules:KERNEL=="mwave", > NAME="modems/mwave", GROUP="uucp" > Within /etc/modprobe.conf files: > > Within any ancient /etc/devfs files: > > Within ancient kernel 2.4.n /etc/module.conf files: > > --------- end modem support lines -------- > > -- View this message in context: http://www.nabble.com/Manu-Khurana%2C-Australia%2C-Fedora-Release-8-%28werewolf%29-tp15237976p15239772.html Sent from the Linux Winmodem Support - Discussion mailing list archive at Nabble.com.
