Martin,
on your
CPU=i686, Fedora release 7 (Moonshine) Kernel 2.6.21-1.3194.fc7
The modem symbolic link is /dev/modem -> /dev/ttySL0
The slmodemd set symbolic link is /dev/ttySL0 -> /dev/pts/2
ALSAversion 1.0.14rc2
Class 0403: 8086:27d8 Audio device: Intel Corporation 82801G
Primary PCI_id 8086:27d8
Subsystem PCI_id 1584:9084
the Si3054 is likely an aborted "Si3054 Motorola",
but I'll send you a scanModem update which should give the complete readout.
Are you starting slmodemd with:
# slmodemd --alsa -c UK hw:0,6
as required by the diagnostic:
/proc/asound/pcm
-------------------------------
00-06: Si3054 Modem : Si3054 Modem : playback 1 : capture 1
Also before trying to dialout shutdown the COMM channels:
# ifconfig
# ifconfig eth0 down
# ifconfig virbr0 down
Check effectiveness with
# ifconfig
though you may have to do the "down"s through your Control Panel equivalent.
If you are using the
# slmodemd --alsa -c UK hw:0,6
and failing, get more detail with:
# slmodemd -d=2 --log -c UK hw:0,6
and send us the output log.
MarvS
scanModem maintainer
On 6/22/07, Firas Kraiem <fkraiem@xxxxxxx> wrote:
Mike
The following might very well be your problem. Please read Bootup.txt for
possible fixes until those messages disappear :
On Friday 22 June 2007 15:39:44 Mike Martin wrote:
> --- Bootup diagnositcs for card in PCI slot 00:1b.0 ----
> ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 21
> PCI: Setting latency timer of device 0000:00:1b.0 to 64
> HDA Intel 0000:00:1b.0: freeze
> ACPI: PCI interrupt for device 0000:00:1b.0 disabled
> HDA Intel 0000:00:1b.0: LATE freeze
> HDA Intel 0000:00:1b.0: EARLY resume
> HDA Intel 0000:00:1b.0: resuming
> ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 21
> PCI: Setting latency timer of device 0000:00:1b.0 to 64
> HDA Intel 0000:00:1b.0: freeze
> ACPI: PCI interrupt for device 0000:00:1b.0 disabled
> HDA Intel 0000:00:1b.0: LATE freeze
> HDA Intel 0000:00:1b.0: EARLY resume
> HDA Intel 0000:00:1b.0: resuming
> ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 21
> PCI: Setting latency timer of device 0000:00:1b.0 to 64
>
> The PCI slot 00:1b.0 of the modem card may be disabled early in
> a bootup process, but then enabled later. If modem drivers load
> but the modem is not responsive, read Bootup.txt about possible fixes.
> Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx
> if help is needed.
>
A "normal" output would be :
> --- Bootup diagnositcs for card in PCI slot 00:1b.0 ----
> ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 21 (level, low) -> IRQ 22
> PCI: Setting latency timer of device 0000:00:1b.0 to 64
>
> === Finished modem firmware and bootup diagnostics section. ===
@Marv : typo on first line, should be "diagnostics" ;)
Firas
--
() ascii ribbon campaign - against html e-mail
/\ www.asciiribbon.org - against proprietary attachments
