Hello, I tried this because of having the same problem with another driver. But one has to make sure that #include <linux/version.h> is above the #if KERNEL_VERSION_CODE! Otherwise the variable and the macro are not defined! Joern Marvin Stodolsky wrote: > Virgil, > > All you have done is OK in principle. > > This problem of config.h absence in 2.6.18 kernel code > is affecting multiple driver compiles, including Intel537 and pctel > modem drivers. One suggested fix in the context of the Intel537 code > was that at occurences of > #include <config.h> > replace this call by: > > #if LINUX_VERSION_CODE >= KERNEL_VERSION(2,6,18) > #include<linux/autoconf.h> > #else > #include<linux/config.h> > #endif > > Within the afflicted drivers/amrmo_init.c , I have tried a few > variants of this fix without success. For example for an attempt > with: > ------- > #if LINUX_VERSION_CODE >= KERNEL_VERSION(2,6,18) > # define POST17 > #endif > > #ifdef POST17 > #include <linux/autoconf.h> > #else > #include <linux/config.h> > #endif > ------- > mimics a similar older conditional in the code. > A compile with 2.6.17 sources succeeds. > But with 2.6.18 sources there is a failure at: > > make all KERNEL_VER=2.6.18-1.2798.fc6 > make[2]: Entering directory > `/usr/src/modules/slmodem-2.9.11-20070116/drivers' > make modules -C /usr/src/kernels/2.6.18-1.2798.fc6-i686 > SUBDIRS=/usr/src/modules/slmodem-2.9.11-20070116/drivers > make[3]: Entering directory `/usr/src/kernels/2.6.18-1.2798.fc6-i686' > CC [M] /usr/src/modules/slmodem-2.9.11-20070116/drivers/amrmo_init.o > Floating point exception > make[4]: *** > [/usr/src/modules/slmodem-2.9.11-20070116/drivers/amrmo_init.o] > Error 136 > make[3]: *** > [_module_/usr/src/modules/slmodem-2.9.11-20070116/drivers] Error 2 > > The lethal "Floating point exception" issues are far beyond my C code > knowledge. > Hopefully maintainer Sasha will be able to work up a fix soon. > > MarvS > scanModem maintainer > > > > > > > On 1/16/07, Virgil Bevans <vbevans54@xxxxxxxxxxx> wrote: > >> Have tried to install both 'kernel-devel' and 'kernel.src ' >> packages. In >> both cases yum reports 'does not update installed packages--nothing >> to do'. >> Tried to follow kernel source configuration directions in "Compiling >> drivers >> for newbies" on this site. 'make mrproper' and 'make clean' both >> fail in >> the [clean drivers] section with 'no such file or directory' (don't >> remember >> what file it was looking for--sorry. >> >> Made sure symbolic link '/usr/src/linux' pointed to correct folder >> and tried >> to 'make' slmodem driver--using slmodem-2.9.11-20061021. Process always >> fails at: >> >> CC [M] /....../amrmo_init.o >> /......./amrmo_init.c:46:26: error: linux/config.h: No such file or >> directory >> >> body of ModemData.txt follows: >> >> Only plain text email is forwarded by the DISCUSS@xxxxxxxxxxxxx List >> Server. >> Do use the following as the email Subject Line: >> SomeName, YourCountry Fedora Core release 6 (Zod) >> Kernel kernel 2.6.18-1.2798.fc6 >> This will alert cogent experts, and distinguish cases in the Archives. >> YourCountry will enable Country Code guidance. >> Occassionally responses are blocked by an Internet Provider mail >> filters. >> So in a day, also check the Archived responses at >> http://www.linmodems.org . >> Local Linux experts can be found through: >> http://www.linux.org/groups/index.html >> -------------------------- System information >> ---------------------------- >> Fedora Core release 6 (Zod) >> Kernel >> Linux version 2.6.18-1.2798.fc6 >> (brewbuilder@xxxxxxxxxxxxxxxxxxxxxxxxxxx) >> (gcc version 4.1.1 20061011 (Red Hat 4.1.1-30)) #1 SMP Mon Oct 16 >> 14:54:20 >> EDT 2006 >> scanModem update of: 2006_December_25 >> >> >> USB modem not detected by lsusb >> >> Modem or host audio card candidates have firmware information: >> >> PCI slot PCI ID SubsystemID Name >> ---------- --------- --------- -------------- >> 00:09.0 10b9:5459 14fe:9100 Modem: ALi Corporation >> SmartLink SmartPCI561 56K >> Modem >> >> Modem interrupt assignment and sharing: >> 169: 0 IO-APIC-level ehci_hcd:usb3 >> >> --- Bootup diagnositcs for card in PCI slot 00:09.0 ---- >> ACPI: PCI Interrupt 0000:00:09.0[A] -> GSI 17 (level, low) -> IRQ 169 >> 0000:00:09.0: ttyS2 at I/O 0xe428 (irq = 169) is a 8250 >> 0000:00:09.0: ttyS3 at I/O 0xe440 (irq = 169) is a 8250 >> Couldn't register serial port 0000:00:09.0: -28 >> >> === Finished modem firmware and bootup diagnostics section. === >> === Next deducing cogent software === >> >> For candidate modem in PCI bus: 00:09.0 >> Class 0703: 10b9:5459 Modem: ALi Corporation SmartLink SmartPCI561 >> 56K >> Modem >> Primary PCI_id 10b9:5459 >> Support type needed or chipset: slamr >> >> >> The modem is supported by the Smartlink slamr driver >> plus the slmodemd helper utility. Read the >> Smartlink.txt and Modem/YourSystem.txt for follow through guidance. >> >> Writing Smartlink.txt >> ============ end Smartlink section ===================== >> >> Completed candidate modem analyses. >> >> The base of the UDEV device file system is: /dev/.udev >> >> Versions adequately match for the compiler installed: 4.1.1 >> and the compiler used in kernel assembly: 4.1.1 >> >> Kernel-header resources needed for compiling are not manifestly ready! >> >> If compiling is necessary packages must be installed, providing: >> kernel-source-2.6.18-1.2798.fc6 >> >> >> Checking pppd properties: >> -r-xr-xr-x 1 root root 312956 Jul 24 13:54 /usr/sbin/pppd >> >> In case of an "error 17" "serial loopback" problem, see: >> http://phep2.technion.ac.il/linmodems/archive-sixth/msg02637.html >> >> To enable dialout without Root permission do: >> $ su - root (not for Ubuntu) >> chmod a+x /usr/sbin/pppd >> or under Ubuntu related Linuxes >> chmod a+x /usr/sbin/pppd >> >> Checking settings of: /etc/ppp/options >> lock >> >> >> Don't worry about the following, it is for the experts >> should trouble shooting be necessary. >> ========================================================== >> >> Checking for modem support lines: >> -------------------------------------- >> /device/modem symbolic link: >> slmodemd created symbolic link /dev/ttySL0: >> Within /etc/udev/ files: >> /etc/udev/rules.d/50-udev.rules:KERNEL=="modems/mwave*", >> NAME="%k", >> GROUP="uucp", MODE="0660" >> Within /etc/modprobe.conf files: >> >> Within any ancient /etc/devfs files: >> >> Within ancient kernel 2.4.n /etc/module.conf files: >> >> --------- end modem support lines -------- >> >> _________________________________________________________________ >> Type your favorite song. Get a customized station. Try MSN Radio powered >> by Pandora. http://radio.msn.com/?icid=T002MSN03A07001 >> >> -- Dr. Joern Wuestenfeld Forschungszentrum Dresden - Rossendorf Abt. FWKH Tel: +49 351 260 3263 Postfach 510119 FAX: +49 351 260 3700 01314 Dresden eMail: j.wuestenfeld@xxxxxxxxxxxxxxxx
