Sébastien CRAMATTE wrote: > Hello, > > I've setuped an ethernet bridge on a debian sarge 3.1 with l7-filter + > ipp2 shapper rules > The server is a supermicro p4sci + celeron pentium 4 base 3ghz + 512Mb > + 2 ethernet e1000 > > One interface is connected to a cisco catalyst switch > The other interface is connected directly to a CMTS (a sort of router > for cable modem) configured as bridge too. > > More than 20Mbps of bandwith cross this bridge. Most of this traffic is > p2p (~80%) > When traffic goes over 14Mbps the bridge seems to saturate (overflow ? > ) and start to make colision and loose packets > > I've take a look to this paper > http://facweb.cti.depaul.edu/jyu/Publications/Yu-Linux-TSM2004.pdf > > And with a duron 1,3Ghz+512 mbps he obtain these values > > Input Rate 28,444,444 > (bps) > Latency 29 > (us) > Throughput 28,000,000 > (bps) > Linux CPU 77% > Occupancy > > A duron 1,3 is less powered than a celeron p4 3 ... So I don't > understand why I've got this problem :( > > > When I make a "top" or "uptime" all seems that works well ... > I've got rrdtool graphs that check cpu and load and seems normal too ... > > Does someone have got somes ideas ? > Any clue or tips to isolate/resolve the problem are welcome > > > Regards > > _______________________________________________ > LARTC mailing list > LARTC@xxxxxxxxxxxxxxx > http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc > > > The problem you have is caused by L7-filter There is a performance problem with this filter . _______________________________________________ LARTC mailing list LARTC@xxxxxxxxxxxxxxx http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
