thanks very much for the info and the sites youv'e included. : ) . i will just buzz-in again if i get into trouble making things to work van ----- Original Message ----- From: "Joel" <zealous@xxxxxxxxxx> To: "van" <VAN@xxxxxxxxxxxx> Cc: <lartc@xxxxxxxxxxxxxxx> Sent: Friday, August 29, 2003 5:45 PM Subject: Re: where do i start? > Van .... > > You need to see http://docum.org it has good examples. > > and the masters guide is at http://lartc.org > > joel > > On Fri, 2003-08-29 at 14:34, van wrote: > > to everyone, > > > > hi people, am new with this things(advance routing/traffic control). > > my query is this, i will be testing out this setup. > > i have already bridge a 2-port ethernet card(ex eth2, eth3), not > > physically assigning any ip address to this ports. the bridge was > > assigned with an ip instead. now, my problem is controlling > > bandwidth of traffic flowing on the ethernet port(ex eth3) which is > > based from the routing made on the machine(for example i have routed 3 > > diferrent ip blocks to pass thru the ether). how will i set limit to > > traffic used per individual ip block(ex. 1st ip block limited to 1MB > > of traffic, 2nd ip block limited to 2MB of traffic, 3rd ip block > > limited to 3MB of traffic). > > > > any links, websites, documents and knowledge you might share will be > > very highly appreciated.. > > > > thanks > > van > > > _______________________________________________ LARTC mailing list / LARTC@xxxxxxxxxxxxxxx http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
