Destination Gateway Genmask Flags Metric Ref Use Iface
166.50.32.1 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
176.30.3.192 0.0.0.0 255.255.255.192 U 0 0 0 eth2
10.2.2.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 176.30.3.193 0.0.0.0 UG 0 0 0 eth2
eth2 Link encap:Ethernet HWaddr
inet addr:176.30.3.38 Bcast:176.30.3.255 Mask:255.255.255.192
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:98373 errors:0 dropped:0 overruns:0 frame:0
TX packets:116675 errors:0 dropped:0 overruns:0 carrier:0
collisions:1015
RX bytes:76086367 (72.5 Mb) TX bytes:97127829 (92.6 Mb)
ppp0 Link encap:Point-to-Point Protocol
inet addr:166.50.33.32 P-t-P:166.50.32.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:4 errors:1 dropped:0 overruns:0 frame:0
TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:40 (40.0 b) TX bytes:61 (61.0 b)
the gw with the lowest metric determines which connection will work..
i cannot add in both gw and make both connections work at the same time..
that is my problem..
On Tue, 18 Dec 2001, Christoph Simon wrote:
> On Tue, 18 Dec 2001 14:00:06 -0500 (EST)
> mok2 <mok2@xxxxxxxxxxxxxxxxx> wrote:
>
> >
> > I am not tyring to route outbound traffice through ppp0 just recieve
> > traffic on that interface.
> > while still being connected to my cable provider..
> >
> > and yes i have a dynamic ip on ppp0 and a static for my cable..
>
> In that case, I'm not sure to understand your problem. You are not
> going to have any multipath route; it a standard setup.
>
> --
> Christoph Simon
> ciccio@xxxxxxxxxxxxxxx
> ---
> ^X^C
> q
> quit
> :q
> ^C
> end
> x
> exit
> ZZ
> ^D
> ?
> help
> .
>
> _______________________________________________
> LARTC mailing list / LARTC@xxxxxxxxxxxxxxx
> http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/
>
