I dont see any collisions when make ifconfig, i feel the problem is in forwarding the packets by the linux box inbetween the interfaces, it is here that there is lot of packet loss, Do you think it to be so Thanks & Regards, Vishal Gandhi ----- Original Message ----- From: "Lars Gaarden" <larsg@eurorights.org> To: "LARTC" <lartc@mailman.ds9a.nl> Sent: Thursday, January 02, 2003 4:52 PM Subject: Re: [LARTC] speed problem > Vishal Gandhi Kommineni wrote: > > Warm wishes for the new year 2003, > > thanks for the reply, i found that there are collission when i use a hub in > > between, > > How do i make sure that both the ethernet cards are running in half or full > > duplex mode, > > how do i check if weathere an ethernet is in half or full duplex mod > > > Could you provide the output from 'ifconfig' and 'route -n' on A, B and > C? This is either a reverse DNS, duplex mismatch or routing problem. > > To see if your are full or half duplex, see if ifconfig reports any > collisions on the eth interface - on full duplex you never get any > collisions. > > If it takes a long time from you try to connect until it starts > downloading, you have a DNS problem. > > If the download is incredibly slow and one or more of the network > interfaces on A, B or C report a huge amount of collisions, you > have a duplex problem. > > Routing problems usually result in not being able to connect at > all, which doesn't seem to be the case here. > > -- > The content of this message can either be used according to normal > copyright law (including quoting and personal copies) or by the terms of > the GNU Free Documentation License http://www.gnu.org/licenses/fdl.html > > _______________________________________________ > LARTC mailing list / LARTC@mailman.ds9a.nl > http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/ >
