> On 04/14/2011 06:14 AM, BrillyWu@xxxxxxxxxxxxxx wrote: > > On 04/13/2011 02:05 PM, BrillyWu@xxxxxxxxxxxxxx wrote: > > > > >> > > > > >> + /* cpuid 0xC0000001.edx */ > > > > >> + const u32 kvm_supported_word5_x86_features = > > > > >> + F(XSTORE) | F(XSTORE_EN) | > F(XCRYPT) | F(XCRYPT_EN) | > > > > >> + F(ACE2) | F(ACE2_EN) | F(PHE) | > F(PHE_EN) | > > > > >> + F(PMM) | F(PMM_EN); > > > > >> + > > > > > > > > Are all of these features save wrt save/restore? > (do they all act > > > > >on state in standard registers?) Do they need any control > > > register > >bits to be active or MSRs to configure? > > > > > > > These features depend on instructions for the PadLock > hardware engine of VIA CPU. > > > > The PadLock instructions just act on standard > registers like general X86 instructions, and the features have been > enabled when the CPU leave the factory, so there is no need to > activate any control register bits or configure MSRs. > > > > > I see there is a dependency on EFLAGS[30]. Does a VM > entry clear this bit? If not, we have to do it ourselves. > > > > Yes, PadLock hardware engine has some association with > EFLAGS[30], but it just required that the EFLAGS[30] should be set to > "0" > > before using PadLock ACE instructions. It is recommanded > that execute > > instruction sequence "pushf;popf" to clear this bit before > using ACE instructions. > > AFAIK, the VM entry never sets the EFLAGS[30] bit, so it > seems that we do not have to do it ourselves. > > I don't think we need to. kvm kernel code doesn't use padlock; other > sources which might set EFLAGS[30] are: > > - the guest; but VMEXIT clears EFLAGS > - userspace; but syscall/sysenter/int instructions clear EFLAGS[30] > - another kernel thread; there is likely a popf in the context switch > path somewhere (we should verify this) Thank you very much for telling me where the EFLAGS[30] might be set and cleared. In fact, adding the CPUID support into kvm kernel code is just to provide correct result for the calling of the "kvm_arch_get_supported_cpuid" function in Qemu-kvm application. There is no dependency on EFLAGS when calling VIA CPUID instruction. Before using padlock engine functions, the application first need detect is the features exist through cpuid instruction, then use ACE and other instructions such as PHE/RNG/PMM. And as previously said, only the ACE instructions required that the EFLAGS[30] should be set to "0", It is recommanded that execute instruction sequence "pushf;popf" to clear this bit before using ACE instructions. I have re-submitted this patch, please check it. Thanks! -- To unsubscribe from this list: send the line "unsubscribe kvm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
